1. Mark Piercy

    P38 Diesel Injector Pump & Cam Top Dead Centre?

    Don't take the risk with any cracks on the rad, especially if it's under pressure... Ask me how I know😞
  2. Mark Piercy

    What did you do with your Range Rover today

    Oh daaaaamn😍
  3. Mark Piercy

    Discovery Sport Engines

    Very true, never a warning just disappointment 😔🤪
  4. Mark Piercy

    Discovery Sport Engines

    Tdv6? 😂
  5. Mark Piercy

    What did you do with your Range Rover today

    If there's play it's an issue, whether or not it's "the" issue my good man. 🤔👍
  6. Mark Piercy

    P38A Oil loss at the engine

    Well spotted that man👍
  7. Mark Piercy

    P38 Diesel Injector Pump & Cam Top Dead Centre?

    It's quite likely the rubber leak off pipes are split at the ends. If not and it's the fourth injector, the seal around the wiring on the injector can give up and a new one needed😬
  8. Mark Piercy

    What did you do with your Range Rover today

    Around 432.000kms🤩
  9. Mark Piercy

    What did you do with your Range Rover today

    That's miles my dear😘👍
  10. Mark Piercy

    What did you do with your Range Rover today

    Upwards and onwards☝️😎
  11. Mark Piercy

    What did you do with your Range Rover today

    Yip, the outer track rod end, the inner track rod end. A longish bar with a ball joint fitting that screws into the rack end. 👍
  12. Mark Piercy

    P38 Diesel Injector Pump & Cam Top Dead Centre?

    That's an idea 😂 It may be easier to remove the inlet manifold to get to the inner coller nut on the pump and there is the support bracket at the rear lower part of the pump that may need loosening up... It's been a while since I did one🤔
  13. Mark Piercy

    What did you do with your Range Rover today

    You have your outer ball joints and the inner bar with a ball joint on the end. As you know but the rack itself can develop play internally and I hope that isn't the case. What is the power steering fluid like?
  14. Mark Piercy

    P38A Oil loss at the engine

    Thread will undo when turned to the right. The trick is to get the big 36mm spanner over to the left as far as possible and smack it with a hammer towards the right. It will eventually shock it loose. A touch of copper grease on refitting with a couple of good taps towards the left👍 Also check...
  15. Mark Piercy

    P38 Diesel Injector Pump & Cam Top Dead Centre?

    Jeez, the head of the pump should be moved towards the engine block or if sat in the car, clockwise👍
  16. Mark Piercy

    What did you do with your Range Rover today

    You like your excel don't you🤔😜
  17. Mark Piercy

    P38A Front Hub Recommendations

    The only issue is getting the old bearing out as they take a bit of force if old and original. I'd bought some blueprint units and found one had failed after two years😵 I then bought an SKF bearing and used the blueprint outer casing and an original land-rover wheel hub. I found the blueprint...
  18. Mark Piercy

    4.6 v8 not starting after heads skimmed

    It sounds like it's not getting fuel. Is the in tank pump working? Have you checked for spark? I'd go back over the work to see if anything has been overlooked 🤔 Did it run OK before the repair (apart from the original issue)?
  19. Mark Piercy

    P38A How to remove the rear-view mirror?

    Ooh, I had that happen to mine and a little liquide had seeped out onto the center dash... It's like bloody acid🤯