when the bushes wore out on my pedal(300TDI) the pedal wobbled a bit, screetched and bent the push rod slightly

hoping for 14v with a rev. It shouldnt go higher than 14.4v cos of the regulator. If you arnt getting above 12.6 volts then either the alternator or the witring is knackered

If you are getting 14 volts or more at the battery with the engine running then the alternator isnt the problem> Some motor factors can check your alternator for you. I have had the cheap craddocks own brand alternator pack up on me before after a few months so i always buy OE ones now. If...

the brass bushes and pin wear on the 300tdi clutch pedal which gives the squeak and the feeling that its rubbing on something. I always fit lucas master and slave cylinders and was aslo told it was good practice to replace as a pair

the bush'es need replaced when there is excessive movement. If there are cracked and spliting then they will be pretty much knackered. A set of new bushes will make a huge difference

I agree with the numax battery i have two in my 300 TDI 90, Even when it has been left for a week or so it still turns the engine great. I had a Bosch Silver battery in my old TD 110CSW was a great battery but the replacement i got from the motor factors which was the correct on was a pile of...

What about the insa Sahara's ??? there not as aggressive, but do give you a good grip in the mud, snow and ice and arnt scary on wet tarmac. I have been using mine for 3 years now with no complaints

i usually cut the rot out and eld in a patch, remember part of the foot well is double skinned. Cut the rot slightly bigger than the patch so you can Butt joint it, then use a high current on your welder and do the run like a series of spot welds. You will get good penetration without a big...

It shouldnt as it is a direct replacement. BUT TELL THEM ANYWAY TO BE SAFE

Be curious to see how it goes, Not all 300TDI 90's were fitted with an EGR and a CAT. Personally my EGR valve is in the bin and all of the wiring is removed, The cat has also been replaced with a standard not CAT pipe. So how will they Know ?? will DVLA have all of those details on all...

Richards chassis seem to be the most popular ones

I spoke to David bower years ago and he recommended only every fitting the earth back to the battery. Connecting to a bolt on the chassis etc has the possibility of getting caked in mud, corroding getting unreliable. 90% of winches not operating to there full capacity is poor earth. I have...

I looked around in the past for cat 2 imobilizers, To buy one and fit it myself was about £60 to get one supplied and fitted with a certificate was £100. So i went for a Viper cat 1 alarm and imobilizer supplied and fitted with the certification. Worst of all my insurance company (admiral)...

It does sound like a blocked rad, but the temp sensors do go wonky. Best thing to do is after it goes towards the red , stop the engine remove the bleed screw on top of the thermostat and insert a thermostat and see what temp the engine really is. When the head gasket was changed was the head...

i am sure it will

sounds like the starter switch or bad connections at the relay

I'm thinking of fitting a winch on the rear of my 90, I have made a cradle out of 8mm steel which will be bolted through the chassis after i weld in anti crush tubes. I plan on accessing it through a flap in the rear floor. But the sticking point is what /where is it best to cut through the...

the speakers from maplin are pretty good, I have them fitted in the standard land rover plinths, Also got some in the back of the 90 as well. They do sound pretty good

im using the x-eng split charger and 2 numax batteries.. excellant

i know the disco 1 is the same as the 300 defender.