Got a knocking noise from my rear suspension. I've fully polybushed the rear end and still get a knocking noise. When going over bumps especially when cornering. I think possible my roll bar bushes/ball joints are goosed so will be changing them shortly. Do you need to take the weight off the...

????:confused:

1994 'M' reg.

Just in the process of purchasing replacement bolts for when I replace the bushes on my 110. However the drawings show 2 different part numbers for both the YA185790 & YA185791. I need to know which corresponds to my vehicle? :confused:

Just fitted and wired up my four KC 57-series driving lights to my roof bar. What a difference! They don't half chuck out some additional light. I will add another two lights in the form of some 130watt KC DAYLIGHTER long range lights to an A-frame to complete my set-up. This will hopefully...

Can you recommend any? What about the struts, will they require uprating also?

I haven't tested it but I'm aware of a thumping noise on rebound of my suspension. I bought poly upper link bushes and a replacement fulcrum with ball joint, only to realise I have bought the wrong part due to having an SLU fitted. Not knowing what the SLU was at first, I did some...

The Landy is mainly used for towing and hence I don't want to ruin its characteristics by throwing on HD springs and upsetting the ride quality unless I have too.

I require a BOGE self levelling unit (NRC7050), can anyone tell me where I can get one as they appear to have been discontinued????

Just fitted CB and mounted aerial to the rear of roof above gutter only to find that the cable is too short to reach transmitter by about 50cm!!!!!! :mad:

Thanks guys for putting my mind at rest. Hopefully thats all it is. Best not give a ride to the infirm or those with heart complaints mind cos it would be enough to see them off.

That could be feasible but it always seems to be coming from the nearside and not the offside. Surely if it were stones it would occur on both???

I have just wired my rear wiper/wash carling switch and all works well apart from having no orange illumination on switch when switch is on. The green illumination works fine with the side lights yet not the bar. Any ideas???

I have just wired my rear wiper/wash carling switch and all works well apart from having no orange illumination on switch when switch is on. The green illumination works fine with the side lights yet not the bar. Any ideas???

What electrical cables run either down or along the near side C-pillar??? Every now and then I get a loud electrical noise like an electrical short. It doesn't happen often but when it does it's as if someone has shot a catapult at my landy!!! All my electrical systems appear to all be working...

I'm looking at replacing my suspension as it is 18yrs old and getting a little tired. I'm not one for serious off-roading but would like to do some green lanes etc. However, the vehicle is mainly a Tow Vehicle and as such would like a kit that best suits my needs. Any suggestions on which brands...

I'm fitting Boost, Tacho & Volt meters in my Raptor dash and fitting an EGT gauge somewhere discreet to aid fine tuning the pump. CB radio also to be installed, audio head unit, lamp bar driving lights, lamp bar fog lights, rear work lamp & rear wiper/wash all controlled via Carling switch...

I tow this:

Going to get myself a CB and would like to hear your experiences with regards to rigs and antennas. Dont want to spend thousands but a few hundred quid for a good set-up and range isn't a problem. First of all I was thinking about opting for the thunder pole T1000 as it seamed good value but...

Just tweeked my pump 90 deg on diaphragm and 1 1/2 turns on smoke screw. Wow what a difference. Too much black smoke though so turned the diaphragm back to just 45 deg from original setting and 1 turn on the smoke screw. It's now too dark to test but I'm hoping all is good when I test it...