Yeah there normaly quite good but once again the trusty forum has got us out the S##t. :D

Looks like you was right new slave cylinder and she has a good peddle now. :)

How about Bus.

A bit over my price range at the moment.

Thanks for all the information think I will go for the Sealey cp2400 which seems good value.

That shouldn't be a problem as I don't take the Landy off road.

How long does the sealey one last for, for example can it get a set of wheel nuts off without needing a charge.

What volts would you go for does it need to be 24 or would 18 be up to the job

I'm looking into buying a cordless impact wrench as I don't really have the space to put an air compressor anywhere Unfortunately the expensive brands are out of my price range such as Snap on, Makita etc has anyone purchased a budget one i was looking to spend about £100 or are the cheaper...

I will keep everyone posted. Thanks for the help.

Well me dad booked it in for a slave cylinder to be fitted. Although he said the garage disagreed with him :der:

The old boy had a new clutch fitted yesterday as his was slipping he also needed a new flywheel because the old one had play in it, also the spigot bush was fitted and a n ew clutch fork. When we picked the car up yesterday the clutch peddle was right down near the floor and it seemed hard to...

Slave cylinder fitted and all sorted peddle is about half way now and not to the floor, gear changes are much smoother.

Its getting a slave cylinder fitted tomorrow and bled, will let you know what the outcome is.

Cheers ordered a slave cylinder and push rod only £20 for the pair so will start there, can it be bleeded without a pressurised system and do it with a jam jar with some fluid in and a bit of pipe, been told its a sod to do it the latter way

Let's hope its not that I don't fancy taking the clutch out

Thanks matt i will check the slave cylinder for signs of leaks and go from there.

The biting point on my clutch peddle is getting low to the point i have to put my foot through the floor and gear changes are getting a bit notchy, the clutch does feel firm though, i have checked the clutch fluid level and it is fine will it need bleeding or is it an obvious fault, i did a...

Just a heads up for everyone, my Discovery 2 boot handle had started to play up, when you unlocked the vehicle with the fob and opened the boot all was fine but when it had been shut and i tried opening it again it was locked, after a lot off head scratching i found the problem was the edge off...

Thanks for all the help it was indeed the exhaust manifold, two of the studs had broken too apparently this a common problem with the manifold getting hot, we got the two studs helicoiled so jobs a good un