would be cheaper to hire a few hitmen

56 quid for a genuine one, I need to find a good aftermarket non Dayco squeaky thing. My old genuine was ok until last year when the squeaks started. Six years old

Drivers seat, the bit screwed to the seat base, mine shattered today while removing to get to CD changer. Alpaca beige. Anyone have one? For now will be a go at heat welding

Not by much though

6 or 7 years ago

Block mods about £60 to £100 for a small engineering company. Hoses, mine were about £20 each, my repair was less than a removal kit.

I hydraulic hose converted mine

keep it

i think I will go with them and see what it is like in a couple of years, I am currently saving about £9k a year because WFH

Started by thinking of new galvanised chassis. OK, they have given it a good look over and I only need the rear quarter replaced, despite a welded ARB bracket. Should be doing it late next week, or the week after. And a few other bits, then a good waxoyling.

Don't think so, but could not find anyone prepared to do a swap for under £10k.

As long as under £5k I will be ok, I managed to save £9k, but since cannot get full chassis done, shoved some into a ISA.

Mine is going in for welding today, and a half chassis

This is why despite being able to afford one, my car has 5 cylinders

Why is this not covered by LR? This is a manufacturing fault. Would legal action be worth doing?

They are my fallback if I can't get a local company. Have asked the second choice again as there is a loose chassis on their website, first choice shut during COVID.

And gone dead again, will try Fishwick and may as well as CAmbrian

Mine all cracked on the flanges

**itpart version Just worried in case mine pops

Does this look correct? If so, may buy one and chop the othe rend off for hoses https://www.blackdownoffroad.co.uk/product/discovery-2-ace-pipe/#lg=1&slide=2