I fink some people modified their tratters to be able to do it, cos it’s a quicker way of tipping all the water out each week

Sorry - yes, as @andyfreelandy says. I can recommend - took my F1 there when I first got it… I knew nothing of Landies. Asked them to replace the VCU and give it a good once-over. Very happy with the service given, and nice people (couple called Sue and Norbert run it). They only work on...

If you are looking for a garage to sort it for you, there is a specialist Freelander place not too far from you 😉

Nice looking Ninety 👍

Well done on passing the test. Now the hard part - owning and driving the landie 😁

This sounds like either the starter motor or battery has an issue. Have you tested the battery? Does it have plenty of power?

I had a dig-about last week and found one scathing review of a car that had been sold but was not what it was claimed to be. However, I only found the one, and it was from several years ago.

Proper landrovering

… and use a genuine ‘Cooper’ filter 😉

You’d probably need more fuel than 10l to rule the transfer pump in/out, they have large tanks, and you would need to fill it over ‘the hump’. I would first change the fuel filter and prime using the correct method… see @Arctic2 write-up and pics below. Then go from there. The crank sensor is...

Well spotted!

Centre bearings are available for the F2 online - but I’m guessing it’s not an easy job. If that mount is indeed fubar, then I think it’s easier just to fit a new prop. It’ll all be the same age, so preventative maintenance at least.

No

I know - I did one on mine. I thought it would be the same for the F2, but an afternoon of research suggests not 🙄

It certainly looks like it’s a new prop job… I’m just hoping that’s the issue, and not something else!

No idea - not looked further yet

So, although I said I was leaving it, curiosity and a spare hour today beat me - had a nosey under the car at potential sources of the clunk noise and wobble (may be the same issue or different ones). Front roll bar bushes seem tight - no movement with a lever on the bar. Then looked around...

I recently removed a lot of grass near my driveway and laid some nice gravel down. That was after digging a lot of it out and laying some type 1 or something similar, as a base. Anyway, the compactor I hired for the weekend was a lot heavier than that, it took two of us to lift it in and out the...

The sounds can appear to be from somewhere when in fact they are not - so I’d look further than front o/s. Check the rear diff mounts.

Think there is something else to it. Can hear a faint ‘clonk’ at low speed on bumps.