Hi, Does It smell pretrol when you start ? if so you have ignition problem.

Link problem …

Hi, You should look at something like this : https://www.ebay.co.uk/itm/256555846479?

Hi, Do you have the picture of that plug ? The plug can be disassembled, but since it’s old plastic it will break, you so a need a new connector, is a connector used for injectors, 2way JPT(Junior Power Timer) connector …

There is a warning on the workshop manual, that you should never remove the tool ( that keep the timing chain gear in place ) before installing the pump. Once the gear is not maintained it will fall, there is no way to put it back in place. I fear that your only solution is to remove the...

Hi You have changed the modul with a preowned or new one ? If it’s a preowned one how do know is good 🧐 Regards.

Hi For P1110 look next to the oil gauge, there should the air temp sensor unpluged, try to find the wire, somewhere … With the P0190 code, the car start perfecty ? With the engine cold and a stable idle ? If the car start, the fuel rail sensor should be working ( should give you a value with...

Hi, The best that you can do, plug the diag tool, take a full screen picture of the fault reading, post it there ! ;) Regards

Hope it helps :

Hi, Where do find that information that you need to lock the flywheel ? The hp pump is still in place ? Do you have this tool : Ragards

Hi, I have a 2004 FL1 TD4 with only 115 000 miles. I drive it mostly in the city, very little highway, motorway, autobahn ... There is a strong smell when the engine is cold ( outside of the car ), almost nothing but still present when the engine is hot. Should the cat converter be changed in...

Hi, The problem with drive shaft is getting decent ones, sure you can buy one for £100, you put it, it will do the job. But in less than 2 years you probably need to change it again … You need to put GKN driveshafts if you want something that last …

If that clip was undone certainly the pump was changed ? ( certainly the poblem we are looking for ), it was also rotated for and odd reason.

They have been already replaced, but they put poor quality hoses, you should replace them better quality ones. Just behind the injectors there is a filter that is never replaced LLJ500010

Hi, Don’t forget to purge the water separator. For the connector is goes there : You need to slide the metal clip between the fuel filter houssing and the fuel filter. I only see half of the metal clip, certainly broken look for that part YPZ000010 for a replacement. Also where did that...

It will return to dust 🤣 ( sold with almost no rust protection )

These cars are not well serviced, the propshaft should be checked, universal joint can have play, VCU bearing can have the rubber part split. The front diff support can have the rubber part split … Front Whishbones rust, there is one small hole next to ball joint, if it’s clugged … Also next...

Smoke is not normal … Check the boost pipes, the one that you put in picture, sometimes it is split, check the full surface of the boost pipes with your hands to spot any hole or split. Boost can spot the EML light.

Hi, Steel wheels are car specific, only allow wheels can be used with plastic adaptators …

First with the engine cold, does it start on the button with stable rpm at idle ?