One would assume the correct side, on the right lol.

Driving with just one eye open then!

Looking at the state of some people's screens on a frosty misty morning as drive to work/school run that's more than good enough to see out of !

Have a look down the side of the oil filter housing see if there's water in the V, I bought one those vacuum filling kits off eBay for another job and there's a pump in to pressurise the system that's how I found my leak turned out to be the stat housing, water just sat in the V and dried up.

Go for the Gap it will do every thing you want and more, I have one for my 2008 it had drive away locking and one press on remote to unlock drivers door and double press for all doors when I got it and soon had that changed (cant be doing with it ) also enabled wipers to intermittent when you...

Best of luck with MOT after all that.

Might have a long wait for an answer, they've not been on since December 10 2018 !

Didn't the poster have a problem with ABS kicking in?

Isn't that what the archbishop said to the actress lol.

Best trying to remove tints on a hot day then stand a better chance of not leaving any residue behind, must have been tints in back of car I have now and it's been a bloody pain trying to get what ever it is that it leaves behind off !

If the steering angle sensor is out of calibration that can kick the abs in so best get the codes read.

Bonnet in service mode and plenum champer out makes a world of difference when doing engine work!

Wow, must be about 4 foot long !

Don't know about the vd struts, but on the standard ones the strut only turned so far hence being handed. With the strut bolt a 2ft breaker bar and as much weight as you can put on it is close (so ft tight!)

Is that all you got out ! You ain't trying very hard I usually finish up with twice that amount out lol. When you resemble try the CV joint in several different places in the hub , I found when changing both fronts last year that they went in further to the hub in one place than another in fact...

I bought the headlight bulbs you listed and they don't fit mine (2008 my l322) if yours is later they should fit, I couldn't be arsed to send them back know doubt they will get used somewhere someplace.

Hope you went for the can bus ones or the LCM going to love you lol.

Yes old school lol. Might be a right angle drive behind the Speedo , they can get a bit dry giving same fault.

It is known to fix some things on l322 so it's always worth a go.

Got a point there.