you were right the 11 fuse was still there it shifts ok and everything works. I still can t find out why they changed the becm maybe during a long testride this weekend I ll find out after my rover p6 this is the worst car I ever had...........almost no better car to drive in so I ll keep on...

I build in the old becm again which came with the car which was replaced what I mentioned earlier.This one had a code. The car ulocked then I used sync mate and voila the car started.Everything worked ok Only on the display came transmission neutral, but the gearbox worked fine. After 6 miles it...

I have the car for a year now. The dealer can t remember what the cause for resetting the becm was he could only see he shipped and build in the new becm. The whole problem started after washing my car with lots of water , then I had to replace the rh doorlatch and the car got confused.Then all...

Is it normal(what is normal for a p38) after 1,5 years and a 300 euro reprogramming of the becm everything starts all over again ha ha ha

In an earlier thread a had a becm lockout .I had no keycode and tried syncmate. I found the previous owner and he told me becm immobiliser was disabled .I phoned his garage and they told me the becm was send to a specialist to disable the becem. Well the display asks now for a keycode and...

Ok I know what to do. Is it true that a pam number w39 on the becm does correspond with a late 94 p38 like a have. I am not sure a new becm was put in I just found in de back of the car a becm ignition key and speedometer display housing I found that late 94 p38 have much lower numbers.but the...

Thank you for the helpfull lessons

What I read on forums when you do not have a keycode you can use sync mate The lock that was replaced was the passengers side it s a left h drive

So because I do not have the keycode of all the hardware that once was replaced by a previous owner I need nanocom to read the vin in the becm so I can get the keycode from the dealer.

What I am trying to say is that the car always worked fine,He only asks for his keycode now.The only thing I try to do is to let the ecm and the becm correspond in order to start the engine.Doing this with sync mate is I think the same as entering the keycode at the doorlock

Because the code was changed I could do two things Let the dealer search the vin code in the becem through nanocom and then look for the corresponding code in the books or take syncmate and connect the keycode inside the becm with the ecm.The starting procedure always worked fine so far I am...

p38 lhd 4,6 After a new rh doorlatch my p38 asked for a keycode.Because a previous owner changed becm I use sync mate to synchronise,I hear the becm clicking so it is making contact with sync mate. With multimeter I checked all wires and coonection ......nothing. What problem could block the...