thanks for the help

so can I do this through the whole in the bell house turning the t conv or the whole transmission has to come off

it is a gems without side plug

first I put exactly the same in as came out .The level stays far above the marks even after a few minutes with a running engine.It seems as if the oil does not spread well. I put some 1litre extra in it stays at he same too high a level . maybe the torque converter does not get enough oil? The...

while changing the starter ring gear the torque converter came out a bit.we pushed it back and finished the job. The automatic gearbox won t shift anymore .It indicates gearbox fault or traction fault. The only thing we also did was changing the oil because the sump screw was leaking. We are...

both where new It was done when I already owned the car a few years ago.

my next question is how come that a starter and ring are damaged already within such a short period .They were new and were replaced by a experienced land rover mechanic.

we just checked the starter ring all over but the ring is too far gone.even when the start of the turning is ok it slips out half way.So I ll have to do the renewal all over again.

p38 gems 1994 4.6hse Within 6000km the ring gear and starter are damaged again.It starts but often with crushing noise. I hoped it would be better with a brand new starter .....but .the gear has at the dead point too much damage. I do not have time coming months to change the gear so my...

problem solved. checked all wires , sensors cleaned everything starts perfect when warm

ok thanks enough look at this weekend

engine is perfect

The starting is only bad after restarting within 2 or three minutes when the enginehas been at max temperature. After 5 -7 minutes the starting is ok and when the engine is about 30 celcius it still starts ok. The bad starting sounds like misfiring with a wrong ignition timing

I have no nanocom I ll have to solve it without

P38 1994 4.6hse had bad start when warm .replaced the crank sensor .problem still the same .Checked all the wiring up to the ecu .What could i do next

my p38 4.6hse 1994 lpg prins injektion starts very bad when half warm.(petrol) Cold start is good (petrol) When maximum temperature it stars automaticly on lpg so no problem.So it could be the crakshaft sensor. I tested it by removing it and then starting with cold engine .....no start. So the...

replaced the starter and starter ring 2 years ago about 12 k km ago

I tried freeze spray, no result.ormal Is it true that an abnormal sound of starter can be caused bij a faulty crank sensor .I changed the starter and ring on the flywheel two years ago. When I start with cold engine I hear the starter only a bit at the end.When I start warm it seems as if the...

p38 4.6 prince multipoint lpg 1994 After replacing becm (earlier thread) engine starts fine on petrol when cold en goes smoothly into lpg modus. When warm it does not start on petrol until the engine cooled down fully. I changed the crank sensor last year.I read that the car will start...

indeed