Slightly but not loads, stoped the oil level going up

Sorry I ment it take 3 attempts to get her started every morning, yes it improved and runs on the 3rd time,

Hi all am working through my little faults with my td5 and I want to no if you lads or lasses recut the injector seats before installing new injector seals mine have already been done but still takes 3 atempts to start on a morning When cold with a plume off white smoke when it starts also needs...

Hi people where is the best place to get a 4 bar fuel pressure regulator diaphragm? Mine isn’t leaking but getting some surging and fueling issues

Hi all I need to replace a track rod end on my disco but it’s the whole arm ( tractor link) would the older set up off the 200/300tdi fit so if I ever need to change a track rod I can only change one ?

Yeah map sensor was clean. I have noticed if the car has been running and you nick it off and turn the key straight back on with in 1-2 seconds the fuel pump in tank is priming again is this right ?

Has had new copper and rubber seals on the injectors along with plunger reset

Hi all, now am getting all my bits and bobs sorted on my 02 plate discovery. The one big bug I need to fix, Start the disco she fires fine ( is cold temps winter will cut straight out but will run on second time) engine seems to idle low them about 5-10 seconds revs pick up to normal idle, but...

Yeah cheers for that lads, I don't fancy lifting that gear box and transfer out again twice in a week is enough, I have done the transfer seal to while it was out

Well Down to it the clutch plate from borgen beck has flywheel printed and gear box side printed on the same side so yes the friction plate was in the wrong way so hopefully will be working later

Just put a new clutch in my td5 disco changed the slave cylinder to now it will go into gear no problem when the engines not running won't go into gear when engines running. Tryed back bleeding it to no joy starting to really p*** me off, any ideas people ??????

That's the one need to replace and see if it fixes it

I have noticed today I doubled checked the fuel pump in tank and found one of the high pressure pipes has been cut and replaced with rubber running under the floor

Dosnt make a difference purging the system starts abit better but it still holds back on reving if you go to drive off it's like the power isn't there then boom it's the alway about 30 seconds after starting dosnt matter if it's from cold or warm start just get the real low idle from cold start...

All heater plugs and relay working fine as should so what's next lads and lasses ?

Just answered my own question ha only 4 heater plugs the old L series used to be like that 4 cylinders with 3 heaters

What's the problem if it's number 5 ?

Never thought about that, are you referring to the glow plugs them selfs or the glow plug relay ?

I have a 03 plate TD5 MANUAL when you first start it dosnt matter if it's cold or warm (worse cold) but fires up runs like it's going to die revs pick up but if you press the throttle it will rev lazy and all of a sudden pick up and rev freely, I have just fitted a regal sport exhaust And new...

Hi all got round to doing the injector seals nice easy job to about a hour, let it prime for about 10 min fired first click of th key but left it over night and now am back to the original problem not as bad but still **** on starting where to go next