The headlamp sits on the electronic adjuster at the bottom, pops on, then at the top there are two plastic fittings that are fitted to the metal headlight frame, these plastic screw type fittings screw onto the two threaded lugs on the top at the back of the headlight, they pull the lamp into...

Replacement unit? Nothing on ebay , nothing I can find listed for it had this problem once be for, can’t remember how I got round it, I’ll have to make something up I think, the plastic screws are fixed in such a way you can’t pull them out without breaking them, no thought...

The clutch fork has gone, fluid is from slave cylinder because it travelled to far, sorry mate but it’s engine or gearbox out to replace, check condition of clutch while you’ve got it apart or you may need to do it all again.

Ok I have 1994 disco it has the oblong headlights which are held in at the top with plastic adjuster screws, these plastic screws are held in place through the metal surround, they then screw onto the lamp housing and you can adjust aim by screwing the plastic screws in or out a little. My...

Yes relay

Cheap thrust bearing

Hi I am looking for a near side front calliper for my discovery 200tdi 1994, the calliper has two feed pipes.

I need a new floor in my O/S front can anyone point in the direction of any sellers of floor panels for Discover y 1994, I’ve had a look round on the net and have drawn a blank on floor panels for Discoverys.

Yes thanks for your help just double checking my self, you know how it gets thanks again

Guys just a quickie Brake calliper front O/S had both brake lines brake when removing to replace swivel housing, I have replaced all that needed doing, but can’t remember which brake line feeds which part of the calliper, I have made up new brake feed pipes, am I correct the line that comes...

Had the offending hub and swivel to bits yesterday, bottom bearing shot to bits , top also damaged I’ve ordered a swivel kit, plus stub axel bearing and seal.

Cost of the bearing is just a few pounds, but as you have the engine and gearbox apart it’s worth checking your clutch for wear and replacing if necessary, as you don’t want to be back here again shortly after doing a thrust bearing. You can buy a Clutch kit which has everything you...

It could have been loose for at least 5 weeks, thanks for your input.

It just sounds very plausible, thrust bearing dry or fairly dry sits over night, you start the car and put the thrust bearing into motion; it squawks fir a little while until it’s warmed up and moved what little lube it still holds. Replacement is gearbox or engine out, but noisy thrust...

could be the thrust bearing making noise

Took my 200tdi 1994 disco for its MOT today and it was failed on a loose swivel pin housing, when on the ramp and the front n/s wheel free he could wobble the wheel quite allot, when I looked on the inside of the wheel I could see the whole hub moving from the bottom of the swivel housing, the...

If it’s as good as you say I’d be inclined to do it up and sell it, what you make off an up together vehicle you should be able to buy the bits you need and have change.

As James said remove the feed pipe from the master cylinder, block the outlet with your finger, get your helper to gently push the pedal down to expel any air from the master cylinder, then reconnect the pipe and bleed the whole thing, this can be a pain to bleed. Make sure bleed nipple on the...

Nice out of confusion clarity or is that yes/no

Indicators I have disco 200tdi 1994 all my indicators work fine, but the display light on the dash does not, I gather then this is a duel circuit, one for the power to the lights them self’s and the second circuit to the dash am I correct? Or am I missing something, I’ve had the relay out and...