yes I think it does, thanks

Hi All, can anyone tell me where the part in the picture goes?It was in the plie for the back door when I stripped my series 3 18 months ago but I cannot remember where it fits, TIA

Hi, I have just finished the rebuild of my series 3 with 2.2 diesel engine. When I started it up all was fine but once on the road the needle went into the red. It is not boiling up so I think it is electrical? I swapped the temp sender for another new one and it made no difference. Fuel gauge...

Hi it is a genuine safari roofed Landrover with the correct sliding side windows and alpine glass

These parts are left over from my restoration any suggestions where they go? I think it is to do with glass fitting

Hi, can I ask advice on what type of theft equipment can be fitted to my series 3? It has a steering lock which is poor and also the engine stop is cable into it. I really don't want a padlock on the bonnet if I can help it, TIA

I think I have worked out how to get pictures uploaded now

Hi I need help to identify parts that were removed from my land rover for its restoration. Not that good with computers so how do I upload pics? Thanks in advance

Thanks for telling me, but it is asked for on registration to this site. Should maybe be a general area like Tayside, but now amended Don't want it stolen

Thanks for the pic that is the same dashboard as mine

Thanks for the reply. That is the panel I have bought, but my dashboard seems different to the one in the picture. I will have another look

Hi I have bought a AUX switch panel for my series 3 but cannot work out where it fits in my dashboard any advice?TIA

Thanks for the reply Mine are rivetted onto the frame but the same seals . Just the new seals are very hard and push against the hinges and lock.

Hi, I hope I have posted this in the right section? I could do with a picture of the front door seal set up please. The set supplied is straight forward with lining up the rivet holes and fitting them, but it also came with a long length of rubber trim. Does this glue on to the new trim or how...

Update. I ordered new half seal retainers from Craddocks. These ones have a lip on the outer edge(unlike mine) to retain there seal. It looks like the problem is solved

The crankshaft journal is spotless there is also no end float on the crankshaft

Hi, I had a rear crankshaft oil leak, so I stripped the engine to remove the rear main bearing cap and the flywheel etc. As per the manual I fitted the split seal complete with the spring first, then the top seal retainer, then the main bearing with the bottom seal retainer making sure the...

Thanks that the right wire and it is now connected, thanks

Hi,trying to find the right section for my post? New to the site. Mine is a series 3 1974. I have identified and connected the indicator switch to all the wires on it apart from a plain blue wire. It seems to be from the headlamp flash section of the switch. Appreciate any advice and apologies...