Out of I treat is this related to engine management at all or just climate control

I should clarify its a 2003 facelift td5 d2

Exterior ambient temp sensor on a disco two, specifically the one that feeds the info to the display of the ambient temperature when you press the ext button on the dash AC controls. Where is it? Because it's either moved against something warm or is faulty as I am pretty sure over the course...

Because my phone hates me, it would be indicative of the position of the leak only up to the level of fuel in the tank. It's difficult to explain but fluid will find it's level so if you have a tank full of fuel the fuel level will only drain back in the lines until it reaches the same level...

Is there an air leak? If the fuel system is allowed to drain back into the tank because of the air leak it becomes hard to start as it has to repressurise, which might account for the insane pump sound, and also the cutting out if the fuel isn't present. I would check for any loose clips or...

i thought that but mine appears to have a keyway in it hence i wondered..

Might seem like a silly question... But lr part number for the zf transmission level plug? And does it require a specific tool, or is mine just rounded, currently I use the universal nut removers that are my mole grips atm

local haunt for me is Porth in south wales,

i think common sense to me would say i needed a roll hoop to stop my face getting squashed.. little bit of mud rash from the place wouldnt do any harm tho.

arent allowed to off road like that any more either .. 5 miles in a straight line to keep a lunch... if only..

that is, if my sources serve me correctly, a storm tuned TD5 with a stage 2 map, centre box delete and a tiny backbox.. i removed the rear section of mine for an hour, eardrums bled but it sounded Lurvely.....

clutch.. from what i have been reading.. have you checked the oil?

by it's very nature it will, because immediately the engine is turned on and on low load the exhaust gases are applying heat directly to the coolant flowing around the block. i have a stack digital temp gauge and it takes on average an extra 5 minutes to reach running temp, in most...

Beat me to it.. hah.. I have one sat in the garage on the dw10 with loom attached Answered my question nicely. Thankyou again gents

The cooler still is in place, and it has been blanked valve side (this was easier anyway) This is the heater unit from most of the hdis, it is simply a little body that sits along side the engine and has no valves or additional pumps, water passes over the tips of four glow plugs (very...

This was an obvious side effect of the egr blank, as mine was fitted with a cooler (15p), the engine now takes longer to warm up. Now this begs the question about a coolant in line heater, dunno what they would be officially called by my Peugeot (2.0hdi) hasa non cooled egr, and a small block...

I sent an email the other day and got an email back, they are still being done and i will enquire about getting some details on this forum (i dont want to post stuff without permission of course)

that was the first thing i checked, no oil at all, hence its pickling me.. it only does it once if it does it and then is fine.. never when cold,

havent checked tbh, i am gonna..