hi folks replaced this small pipe, (landrover dont have any and they want to sell you the whole pipe complete with a sensor for £64 ) i used a straight piece with a gentle curve in it 2 new clips £2.50 from motor factors cured the leak but problem still persists ,trying millers for a few fill...

hi folks had a quick look tonight and noticed a small rubber pipe 90 degree elbow under where egr valve sits appears to be leaking diesel ,so working on the theory if fuel coming out then air getting in, will have a closer look over weekend . Trev

Thanks folks will check these things out , wouldn't I get poor starting first thing in a morning if injectors were leaking or could they just be slightly blocked would a few doses of Miller's help with these ,will break out the spanners this weekend. Regards Trev

hi folks just an update changed both the fuel filter and pump under rear wheelarch still problem persists, feels slightly rough when driving revs between 2-3000 and then if you are at standstill in neutral rev up to 2000 no probs rough up to 3000 revs then clears and is fine all the way up the...

hi, i have a dec 2003 53 plate facelift model and i have the green one. Trev.

my hazard light switch doesn;t illuminate on my facelift td4 just the warning on the dash Trev.

apologies its a 2003 facelift td4 cheers Trev

Hi folks have owned my freelander for 18 months no probs at all, but just recently when driving along in 3rd about 2-3000 revs but not pulling hard it has like a misfire, stationary reving it up slowly its ok upto 2000 misfires abit with blue fuel smelling smoke upto 3000 then clears and...

Common problem happened on my 53facelift most folks don't even know they have rust untill handle comes off as the handle hides the rust untill the bolt pulls through. Trev

check that the brake caliper sliders are free if not brake pads could be sticking and getting hot

Keep it you,'ll miss it I've had 10 landrover/rangerover over the years plus lots of economical cars and always come back to landys so now I have one of each Trev

has it been standing for any length of time if so i have known the splines on the shaft to stick this would give these symtoms as the clutch doesnt disengage properly trev

Merry xmas and happy New year to all freelander owners out there All the best Trev .

thanks for that mate i got a little concerned when front prop wasnt turning now understand whats happening and know it shouldnt be turning . thanks again Trev

hi folks had freelander up on the lift today both front wheels off ground both turn freely but prop doesnt jack up one rear and this cant be turned as it tries to move both props garage say this correct but i dont know ,also one front wheel up and this cant be turned any advice greatly...

Hi Dave X tyre fitter myself didn't quite do it for that long now working in construction industry but in a factory making supplies for it .

Hi My 53 facelift doesn't make any noise at all and no pulsing through the brake pedal when I engage hdc.

Mine does this sometimes , I just move it slightly by hand and try again it usually works might take a couple of trys Trev

I run general grabber at's have had no issues in wet or dry and seem ok for general offroad .

hi duncan s it was good to have met you at the show got some good ideas after you showed me around your freelander ther is a scrap yard near me which has a few freelanders in i will be going there next week so i will have a look for you Trev