Ok I managed to get the bulkhead moving by loosening off the whole front end and got it more or less where it wants to be. However the doors look to low so run a string line from the bulkhead to the rear of the tub and the tub is sitting high at the front. Now I fitted rubbers under it when...

Ok a small update. The bulkhead isn't square. I.e. the door gaps are different on the drivers side it is tighter at the top than the bottom and on the passenger side it's tighter on the bottom than the top. Both bottoms read about 88cm. The top is 87 on the drivers and 89 on the passenger side...

Ok so I have went to for the doors on ky Series 3after rebuilding the tub etc and the drivers one won't shut. I have measured the gap and it's 1cm tighter at the drivers side. When I got the car it had doors on it that wernt to bad out of alighnment and since i never removed the bulkhead thought...

Ok thanks. It did feel a bit tight. Norrie.

Fitted the seat box, gearbox tunnel and floor plates today. Norrie.

I tend to try and put it on with no thinners unless I'm struggling then I just add a small amount probably no more than 10%. Norrie.

Glad you got it sorted and not too expensive for the starter. Norrie.

No idea. There is covers for them. I assume someone maybe had speakers in there or something. Norrie.

Finally finished the front end. I fitted the bonnet and it was totally out of alignment so had to loosen off the rad panel and elongate the holes. It wasn't the original and had been welded but the holes must have been slightly out. I shut the bonnet before tightening it all back up and then...

My new drivers side lock never came with one. Norrie.

Yeah that's the baby. It says it's for an anti burst style lock but I've got the normal door.locks so I reckon I don't.need it. Norrie .

Thanks. Still.not great as got an ear infection In both ears. Managed to wire up the rear lights today and the trailer socket. Also got the front lights back in. Getting there although slower than I wish. Norrie .

Ok so when I got my Series 3 it had Defender doors on it but I have gone back to Series doors. i got a used lock for the passenger door but bought a new one for the drivers door. On the passenger lock there is a thin shim that goes between the lock and the door. Does anyone have a part no for...

Nice video. Norrie.

Not been very well lately so progress is slow. Managed to get the tub bolted in place and fitted the rear lights etc. Also started painting the door tops. Norrie.

Got the bottom of the doors and the hinges in colour now. Norrie

Ok my bad. I checked the plugs today and took them our the box. It turns out the thread is the same it's the hex size that is different. So there now fitted. lol. Nothing to see here move along. Norrie

I will check what plugs I was sent tomorrow. Norrie.

I ordered the original Champion ones from Paddocks. They were listed for a Series 3 hp engine. Norrie .

They are not anti burst. Norrie