Defo agree on the rusting from the inside point of view, I'll Google fertan now!! How did you flush through with water ?

Hi it has just moved into our garage so no more oil on the drive! Possibly! I'll have to look for the drain holes again, don't think I've ever seen any. I've looked into buying a rust remover to spray into the chassis, but they seem to need wiping off then over painted, no use for inside the...

hi all going to buy some dynax cavity wax for the Landy , just wondering if anyone has used it and how much did you buy, don't want lots of it left over and even worse having to buy more. Comes in 4 750ml aerosol cans .Also has anyone drilled holes to allow better access, or added drain holes...

Carnt afford rocky mountain ones, I'll have to make sure the ones I get, get well rust proofed ! ;-)

Cheers for the replies. Think I'll get some sp ones. I've got series 2 door tops on my S3 for some reason. Are the window locks better on a series 3?

Hi all about to get some new door tops at last. anyone fitted SP door tops? Are they any good? £120 for a pair glazed. sounds good value to me.

Still think there's something odd going on, light goes off with a few revs on, battery is getting charged ok, the only thing wrong is that when the light fitting is pushed into the dash it - with ignition on and or engine running - it is fully lit all the time. If the metal part of the dash is...

.....well now you mention it

What are they?!!

By the way there's two wires to the holder. could it be that it's series 2 wiring( + earth ) to a series 3 dash ( - earth)? I'm confused, and fed up!

What's number 27& 33 above? Cheers for all the replies.... forgotten how helpful this forum is :-)

Light goes off when there's a few revs on

Did that .. it lights up!

hi knowledgeable ones! Why does my charging light only work if it's not fastened into the back of the dash? I.e. Plugged in it's on all the time. Hanging loose it works as it should. Why would it be earthing out. Rest of dash is ok. Some background is needed - my Landry seems to be a series 2...

Timing done. Runs well, just need to increase the revs, it's got a Weber carb and the linkage won't adjust any more, it's idling about 550 rpm!

Cheers mate, I don't think there's any side to side play, I didn't notice any anyway..... it's running fine, since I adjusted points, so I'm not going in the dizzy cap again! I'm going to check the timing if it ever stops raining, then I'm shutting the bonnet till Xmas!

Yep it does

Went to change the points and rotor arm in the series and when I tried to adjust the points, noticed I could twist the central shaft loads, a good 25 degrees. I guess this is not good. New dizzy needed or will an electronic points conversation solve it. Was going to get one of those anyway as...

No not a member, do I need to subscribe to trail wise/ memory map? It's all a bit foreign to me!