Hopefully it'll go well. I've already done all the loosening of bolts etc so should be quite straightforward on the strip down. Been thinking a lot about the measuring. Maybe overthinking though lol. Time will tell.

Hi guys im about to embark tomorrow on a 1/2chassis replacement in my d2. I have a couple of concerns as follows. I intend to support rear of vehicle by placing a support across the chassis from side to side just in front of the rear trailing arms. I concerned the body structure may droop after...

Does anyone know how long the slabs timer runs when the ign is turned off?? To clarify I had a flat battery. I thought Id do a drain check and found that after turnining everything off there was a current draw of around 1/2 an amp. I've traced this to fuse 11 (30amp) in the engine bay. Remove...

Thanks.

A quickie question before I but but are the front and rear anti roll bar clamps for bushes the same between the ace and non ace bars ? With the bushes being different. Thanks in advance.

Thanks for all the replies folks. I'll get on it at the weekend.

So to clarify. Fit 2 new bump stops. Then space axle at 61.5mm both sides by removing air from bags and supporting body with 2 jacks one at each side. Then "get current readings" then "get current heights and save heights. And that's all.

Well I have just fitted 2 new front springs as well. But they're heights are fixed and non adjustable.

Yes good shout

They wouldn't be the original bump stops anyway. Is it as crucial as that.

One bump stop is missing. So I set other st 61mm as it was as close as I could get. Then levelled other side with spirit level on roof rails at rear as I have full length roof rails I would have thought that I was near enough at 61mm but maybe not.

No additional load. Just under 1/2 tank fuel. Dog guard. Boot empty. I'm more worried about it dropping at rear and not rising up again. But restart it and it rises to its height. It never did this before. Also i would have thought on airbags the weight was relatively irrelevant as it would self...

Ok so following on from sill and chassis welding I have these possible? Issues. I had to patch behind the left hand height sensor and fabricate and fit a new bracket for the sensor. So the issues were an uneven height at rear due to sensor readings changing. I set nanocom up and recalibrate...

Sierrafery I had viewed this already but my colours if fitment differed from the combinations. Which isn't a surprise. But would any of these combinations do? That's what's confusing me. A mate has a front set lying that are 101340white/purple 101341white/orange britpart springs I suspect the...

Good afternoon everyone. Well an mot fail today but not to bad. All flex brake pipes need replaced and front spring on drivers side. But what springs? I want to keep std but what was std on an 03 disco2 with 7 seats ace and air. GS model. The colour codes have all but gone on mines. Pass side...

Link to advert.

As above. I am looking at an F plate 110 CSW. It looks very fresh chassis wise and overall looks very well. However there are issues I would like advice on. The conversion to a discovery 300tdi and r 380 gearbox was done by the owner before this one. The new owner says the temp gauge reads...