These toys you got rid of some money :D

It is number 20 of picture....

Definitely has oil temperature sensor ......It is positioned near the oil pressure switch...

If the ECT sensor fails or becomes disconnected, the ECM will use a default value which is based on values from the engine oil temperature sensor. The driver may not notice that a fault is present although a fault code will be stored in the ECM which can be retrieved using TestBook. The...

.....if you did that video you have worked well https://www.youtube.com/watch?v=1Qn8ljQKZxA you really need a code reader, you get rid of long time wasted....

I bought the car had different front- back tires..... a week ago we measured the difference in diameter. The front tires were 3 cm larger in diameter:eek:...... but did not produce damage to the transmission....VCU has been tested and is not locked I immediately changed the whole set of...

If no code is received or the code is incorrect, the ECM will disable the vehicle by not energising the fuel injectors. The immobilisation ECU also controls the starter relay and will passively disarm the starter relay when the key is removed from the ignition switch. Rearming is performed by...

• The ECM also operates the engine immobilisation circuits. When the ignition is switched to position II, a coded signal is sent to the ECM from the Central Control Unit (CCU). If the coded signal does not match the signal programmed into the ECM, the ECM disables the fuel injection...

Use a multimeter to check if current flowing through the ckp sensor wires....

Use WD40...

Yes........ pay attention to screw's pretty stuck

The CKP sensor is mounted at the rear of the engine with the sensor tip facing the engine side of the flywheel and is secured in the casting with a single screw. The sensor tip of the CKP sensor is adjacent to a profiled target ring formed on the inner face of the flywheel.

The ECM determines when to operate the injectors based on the signal it receives from the CKP sensor. The ECM provides an earth signal for the period the injectors are required to be open, the injector solenoids are energised and fuel is sprayed into the inlet manifold onto the back of the...

Someone used general grabber at2 tires ??? ...any feedback ? thanks

remove fuel rail with injectors and starts .....just so you can be sure the injectors are working

Easier it is to disconnect propshaft,....have more room to work ....remove screws all diff mount.... check in what condition are....then you decide whether all or only change them centrall mount ...I've changed it all ;)

http://www.landyzone.co.uk/lz/f69/rear-diff-mount-replacement-how-guide-101774.html

Fixing oil leak with partial timing belt removal only. Camshaft oil seal, 1.8 Freelander. https://www.youtube.com/watch?v=sXRhgiy2CQQ

Rave...

Here connectors you need, easy to install.... Land Rover - Install Adaptors | Car Audio Direct