@resto_d1 @boguing I'll buy you both a pint when you’re next in Somerset! But....how do you both interpret the Nano log? I am very new to the Nanocom and struggle to translate it all, there isn't an awful lot out there for Nano noobs like me.

Just got back - feels soooo much better, this is with the MAF connected (was the original one so far as I know it was a genuine LR one). I also removed and cleaned up all the earth points this morning. What is NOT happening now is, when I go over uneven road and my foot inevitably presses the...

Fitted new pedal overlay, feels much better. But ...even better when MAF if disconnected (don't think I am imagining it!). Put a meter on the MAF connector. Just over 12.47v when ignition on and engine off - 13.8v when engine running. Will put the Nano on later and post log Hope you're...

Done it now....biatch if a job tho, at least the way I did it. All fed through, will wire it up tomorrow as it's time for a pint!!!

Erm.....how exactly do you get the new pedal overlay up into behind the dash?? I can see the existing loom from the pedal, but cannot see how to loosen the metal plate its fed behind. Other than that I am good to go!

On it...thanks! 👍

Done injector loom, but will get onto the others - good plan cheers !

The plug, not inside, on that note, the other chip should be here today (should), so I can open up the ECU and see then. But the plugs both looked clean as did the plug at the loom harness.

Thats the spirit!! I'll be able to tell you over the weekend! ;)

Nah, first thing I checked...oil free!

How can it log 3 tracks if its actually only a 2 track pedal - possibly a schoolboy question! Tried three MAF sensors now - the one that was originally in there, the one out of my Disco II and the new one.... Not sure what else to try now.

Here's this evening's Nano log... It seems changing from 3 track to 2 track hasn't done anything really - I assume as its reading 3 tracks there's a 3 track pedal installed(?) Still surging (but less) and less 'hopping'...getting there, I think. The throttle pedal overlay turned up so that will...

Taking it out later this afternoon...will put up the log then - cheers!

Well, that was a different drive!! Not 100% but definitely easier and almost no jumping! All I did was change from 3 track to 2 track via the Nanocom. The only thing was, little or no boost at all in low revs and low speed in a higher gear, necessitating changing down again and upping the revs...

I'll find a pub a bit further away then, yeah? 😁

Evening! Earlier, I hooked up the Nanocom and saw that the throttle was set to a 3 track. So far as I know my 1999 110 (10p) is a 2 track pedal. I reset it to 2 track. I've not gone any further than back from my local after a pint or two of Tribute (Cornish best!!), so can't really report back...

It's all good, managed to pay via Google Pay....will keep the thread updated.

Ah, gotchya.... Trying to order from here, but their website seems to be having issues - do you know of anywhere else?

Thats - yeah, I am thinking of replacing the wiring loom from the throttle to the ECU.... another fooking £60, not much, but it all adds up eh!

Just the one into that connector and its the same gauge as the earthed one to the chassis underneath the ECU. Its worrying though.....what were they up to???