duplicate post

Hi, Nope on the diagram LH one shows the jack and fuse box, RH one shows the relay module under the fuse box Done some checking Turned ignition on and off fuse 1 fine Turned on ( for 1st time since Saturday night)and started went round to engine checked fuse still ok but after approx 30s it...

1.8i engine, yr2000, as for fuse can describe location will have to search to find diagram / fuse list Open the bonnet it is the fuse box on your right hand side as you look towards rear of car and just forward of the jack stowage point, remove cover and again from the front it is the rear row...

RAC been it is blowing the 30amp starter motor fuse when you start it he thinks it is one of the other functions that comes on when you start it one of the sensors, so it will have to go into my electrical man tomorrow. thanks all dingdong

Thanks Nodge, let you know later how it went terrier989

think I found where it went down could not access it, meanwhile RAC rang and moved my call till tomorrow morning, not best happy with them the amount of money I pay them annually terrier

now to show my ignorance where is the starter located, got to walk the dog shortly so can take a torch and go try that cheers terrier

HI All just drove down the shop came out used fob to opened vehicle, put key in ignition turned on all dash lights come on those that should go off so BUT turn the key zilch not a click not a thing, deadsville, windoes lights all work. Re locked car with fob (me inside) tried to start alarm...

same engine isn't it, but a higher CC?

Thank you terrier

Hi All, I do very low mileage , belt changed july 2016 not done 15k yet, with such low mileage is there a time between changes? cheers terrier

Hi here are the images [/IMG] [/IMG] That "cup" section was almost 1cm shorter on the europart item compared to the bearmach one. It looks like the shaft has been bashing against what appears to have been three fingers extending towards centre, and I assure you there was no vibration in 2...

Update - its fixed Changed front prop ( bearing worn) no joy. Put it i 2wheel using a blanking plate, found whent holding crown wheel unit in hand and rotating shaft bearings felt graunchy , found a recommended refurber who sold me the 2 bearings (timkin), oils seal and crush washer under £40...

will do thanks, got ot back in 2 wheel at the moment as I need transport.

one wheel test took 42s with a 5kg weight If i recall correctly this is too long?

No vcu is still on, what i am asking is if I just remove the front propshaft can I drive it as a 2 wheel drive for a while or do iI need to remove the rear one and vcu. I don't know if driving it with the vcu fitted and no front shaft if the rotation from rear wheels will damage vcu cheers...

being done. tyres yep all same and same pressure least worn on the rear what abt VCU if I go 2 wheel drive for a while shd I have it removed

update no vibration in 2 wheel drive put new prop on still got vibration they are going to do the VCU test next, if that is ok I assume could be vcu bearings or something aft of that in the drive train If I drive it in 2 wheel for a while do I need to remove the vcu to prevent it being damaged...