does it have the same properties of Dum Dum(i mean will it be hard when i need to remove roof for ex..) and can you tell me if possible from where to aquire online? and what clear/trasperent sealer you would suggest to use on a defender body(i am goint to put it on the paint i have to have...

hi to all does any one know where i can find to buy dumdum or a replacement for dumdum with the same properties since i think they stopped producing it? thaks

i put a 1mm wire but the problem remained...i think that the gauge is giving a higher reading .,....

earth strap to engine is good (12mm cable)...it is the same 200tdi engine i had ...the gauge part number is prc7311 and the sensor is prc8593 ...can it be a damaged resistor in the gauge?

hi lately i made a full restoration to my defender 90 and i have a problem with the temperature gauge..as i start the engine it works fine from cold but after a couple of meters it runs up to the red zone ...i removed the thermostat to see if it is jammed and left it out to see if it was the...

i figured the wiring out all i need is a plug to fit into the three pin connector since they are to close to use wire sliding terminals the smallest i found where 2.8mm and they do not fit they are to close to each other...where can i find a connector or a harness if i cant find the connector...

yes it is a rear door wiper motor.. it is the one with two rectangular plugs..any help diagrams welcome :)

hi everyone lately i cam across a wiper motor for a defender its part number is AMR3676..i think its from a 300tdi can anyone help me with the wiring since my defender does not have a motor installed and no switch in the dash...i want to install the motor from scratch ... any help most...

well guys i started a rebuild lately and just wanted to give a different colour to the springs so i sand blasted them to repaint them ...i was told by another guy that the tall ones go on the driver's side 10x for all your help hope to be able to post pics of the process in coming days:D

hi i had a set of coilsprings on my 90 which i took for sandblast to re paint but now i have a problem i do not know which is which they have a sort of a serial number on them....anyone got any ideas:eek:

hi taffi_jj can you please send me any pics and tips since iam on the way to change my bulkhead regards

hi does anyone has an idea of how much does a defender 90 chassis weigh??;)

multimeter checked the wirings everything is fine...when i remove the connector from the sender the gauge needle goes down so i am going to get a new sensor/sender tomorrow to try to figure it out

al wirings are fitted in place and there are no shorts can it be the sensor ??

hi guys yesterday i changed the bulb of my temperature gauge on my ninety and when i fitted back the dash i switched on the lights and all worked fine. after a while i switched the ignition and the tempretaure guage needle went straight up all the way to the red zone...any ideas of what the...

can anyone please tell me wher i can get a seal kit for my j19 2.5td cav pump? regards

hi does anyone has an eploded diagram of the injector pump of the j19 engine i think it is a lucas cav regards

nice pics drizz continue updating with pics pls looking forward to do almost the same on my 90 :D

ill check it out for you and 10x

i prefer the 265's