Before this happened if I kept foot on brake it would make a whoo noise 🤣

Hi First off thanks for helping me. I haven't diagnosed nothing. It's just when I brake they work fine but take my foot off the brake and back on it goes solid then if I drive a little it goes back to normal. Yes it branches into 2 pipes. Thanks

Do you think it could just be the break master cylinder as there is oil on the vacuum hose where you clip them both together?

I'm not sure if its been replaced before as in my ownership the breaks have not been spot on even though I have put new discs and pads on and I have seen in another post that it effect,s the gear change and mine doesn't change down when you want it to.

Ok I have bought it now so hopefully it will work. Thanks for the input tho.

Ok just didn't know if they updated them as there was a recall and they both look identical

Anyone know before I buy it ? Thanks

Hi I have a rrs 2.7 tdv6 on a 2006. The break servo isn't holding the pressure as when I turn the engine off you can hear the air coming out. Now the part number is SJG 500045. Is AH22-2B195-BB the same anyone know. Thanks Stephen

Sorry its the l320 2.7 tdv6

Hi everyone I have just replaced my rear discs and breaks blead them buy now if your on the break peddle for a bit the peddle goes hard but the breaks bearly work. Any ideas? Thanks Stephen

It has 3 wires going to the plug but there red blue and green now when i got the car they were black red and blue and the black 1 was disconnected so i replaced the whole lot back together but like i say the obd reader doesn't pick the fault up

Its a 2006 range rover sport hse 2.7 tdv6

Hi mate it doesn't move at all it just stays the same fully down. I have done a collaboration myself as my obd reader does it but it never comes up with a code for the sensor

Just noticed again thats what i said rear passenger wheel in the first message 🤣

Yes sorry i just noticed i said right 🤦🏻‍♂️

I just copied what the last owner had done

I have tried that. The last owner had replaced the plug and 1 wire was hanging off so i got a new plug and sensor but not sure if the 3 wires are the right way around

Ive also put a new plug on but its still the same. The suspension works fine it just goes down every night but if i disconnect the battery it stays up

Hello mate Yeh its not recognising it. On the 4x4 screen its permanently down. Ive done a calibration on it with my computer. Thanks