My D2 Td5 Auto, I'm unable to delete, got going again.

C594 Auxiliary power connection. Center console 12v if fitted and other bits and bobs. Mike

all sorted changed the fuse box still the same it was the ecu thanks for all your suggestions

If you need spares this guy is good Call Paul on 01206 211623 - office 07828 278465 07760 955966 07840 428888

Thanks, in the end I gave it several coats of Raptor and used plastic washers under screws.

try

Just switches and a fuse board ? O' for the good old days. 😁 My Series has but two fuses. Apart from the heater plugs, not even a relay !

Don't leave me/us hanging. How are the circuits controlled ?

It's all sorted ;)

Could water be getting into the BCM module ?

Unplug one side HID unit, plug in a normal H4 bulb and see if the flickering still occurs, if it does the car is at fault, if not the HIDs are duff, simple and no fancy knowledge needed. Do not lean the H4 bulb against anything soft/plastic as...

I would look for an earth. 🤔

Maybe they share an earth? Now SF will come on and tell me they are switched through the earth!!!! I have no idea!

You could always check to see if both are getting power when the switch is pushed, give them a good dose of looking at. They may have simply seized.

1978 warehouse Pallet truck.😚

I mean, you can cut the rest off so nothing is there and then they can’t test it so it won’t fail. But I’d be inclined to replace them cause it sways like a cowgirl on a buffalo without them, in my opinion. If you did replace, you can get +2 drop...

You've got it. Front fogs were only fitted to models that also had automatic lights, and headlamp washers too. Auto headlamp switches also controlled the back lights of the Ipack, changing the brightness in relation to how much daylight is in the...

Started fitting a new air con fan motor on my son's Td5. Bit of a faff as he has front spot lamps and all the fan housing screws snapped. Just soldered the wires today and will refit the spot lights once I have painted the mounting bar. Oh...

Agree with Sierra, those DTC's don't really mean anything. Have a good look around starter, just beware of live wires ! Can't recall the part name but I had the ignition barrel fail on mine which resulted in non start, but this was a gradual...

Unfortunately you can't rely on those fault codes cos Foxwell is not reliable with the Td5 engine management codes that's a verified fact, first of all this has nothing to do with the engine management or fault codes and if you unlocked with...

My favourite saying, start where it stopped. Check all connections and hoses around the MAFF and air intake are secure. Can you hear the pump when you first turn ignition on and do you of course have diesel in tank ?

So, I had to move the old Disco so I could do some strimming, but found the key fob wouldnt open the doors. Luckily one of the rear doors locks is knackered, so I still had a way in. None of the fobs would open the deadlocked doors, so found some...

Well, at least you know.

That's a valid point. If you're fitting cheap parts you want to be paying cheap prices.

I fitted the black 'Britpart' ones without issue.

I bought my 2008 FL2 on Sunday, heavily discounted because it failed WOF (like MOT) on no power in the steering below 5-10 km/h. Power assist mostly works when driving very slow, and this failure is a known weakness in Ford era Freelanders. In...

I've seen worse

Anything that was working up to the point of the break down is probably still ok, except for one thing. So don't go trying to change stuff until you know it is fubar. Putting petrol down the throat of the carb may have been too much for it...

Thank you. Will give this a go too.

That is good lasted longer than my frying pan 😀 and that don’t go very far at all