I arrived back in the UK today so will start to get the RR sorted and up for sale or at least one of them. Flew from Brisbane to Bankock with Singapore Airlines and then flew up to Chang Ria the next day with Air Asia and spent a couple of day...

is the DPF blocked ? in the handbook for the D3 it says run the engine for about 20 min at abve 2500 rpm to burn it clean i dont know what the D4 hanbook sugests but if you have one look under DPF or diesel particle filter

can you check with a NANOCOM and operate them with it?

When my turbo s--- itself i was in Kazacstan and it started howling like you would not believe and every one moved to oneside believing it was either an ambulance or police car it also left a trail of oily smoke that caused its own ecosystem and...

THE hp 24 will fit but u need to change the bell housing and torque converter you could also try using the Lucas gearbox fix

I would like about 2500 GDP for it . I will be in the UK on June 12 2025 for a few weeks

I have a 1999 P38 in Roja red 2.5 DSE for sale . This car has been used for overland trips and has been stored in a lockup since covid I used this car for trips through Russia Mongolia Uzbekistan China and Europe and keep it in good condition...

If you were in AUstralia you can also buy 6x6 landrovers and tray back UNIMOGS https://afmsafety.com.au/land-rovers/land-rover-110-6x6/

This mourning i went for a walk and sw a vehicle that i havnt heard of for sometime and thought some people might be intrested in .It was in camper form and looks the buisness for serious off road travel. Its an OKA and built in Australia...

I had tints on my P38 when i bought it but had to remove the drivers and passengers window ones as they were illegal as the police could not see if you were on the phone

My disco has DSC on it and when your in soft sand it will just dig itself in same with thick mud so the first thing i do in either situatin is turn off the DSC . I learn that the hard way the first time i was in soft sand it dug itself into the...

Might have to get it into a 20 ton press or use a grinder on it

Sent you a pm