Nope, or is it yep? Just thought I would get in before you did ;). I just wondered if it was warm enough for a dip this time of year, our pool covers not coming off for a month so it could be a bit chilly around the knees. J

You make one little mistake and people just don't forget:D:D:D

Why? Broke down? or eyeing up the gap in the fence to the pond 🤔 :p. No its never going away:D. J

sitting here 🤩

Swapped out my return pipes as one had split twice yesterday. 👌

Do you mind its not the freelander section :vb-biggrin:

Shouldn't they be commercial rated Tyres also?

Hi, all sorted now, thank you for all your help, it was in fact the ignition switch,

The pipes rust just as they come out the intank pump and leak or let air in. There should be no air in the clear pipe going to the fip. 3 bolts hold the cover on over the rocker cover then it can be slid out to look at the fip and leak offs...

Check around the tank anyway, if it's wet it could be the source of the air in the li es👍

Need some guidance from the Diesel experts out there. A local guy & his son stopped by today to see if I could figure out his problem. He's had the P38 since 2002 & it generally seems well looked after. My Nanocom doesn't yet have EDC...

That starter speed is good, I'd look under thé car near thé fuel tank, if it's damp looking it's leaking diesel from the top pipes on the fuel pump, also bridge the fuel pump relay and listen into the fuel tank. No noise, no pump. 👍 check around...

Easy to do the blend motors without removing the dash

Always unlocked and doors open when disconnecting the battery. Same when reconnecting. If inside then put the front windows down first as well.

Yes both will now be high but the BECM mileage will go to zero with the memory chip removed from the cluster when the cluster is reconnected. It then remains to reprogram the memory chip with the required mileage which will then update the BECM...

ok, thank you very much! I will replace everything except the arm. I will report back.

Well…it’s easier to get in when the doors open? 🤭

Do the nut (5) at the far end first. It's easier while the axle end is still attached. Then undo the two marked 7 & 8 in the diagram. If the bolts are fouling on the roll-bar mounts, just undo them & let the roll-bar hang down a bit. Also do...

Maybe the transfer motor has failed ?

Definitely remove the arm from the car or you are asking for trouble! Chamfer the leading edge of the bush as well, it'll introduce itself better before you press it Into the arm. A touch of grease as well around the whole in the arm and the bush...

Thanks All. Spoken to a chap in Wales. Les Edwards. We have a plan 👍🏻

I fitted the polybush on the antiroll bar, it made a difference for me👍

Sorry, only the instrument cluster will need the mileage reprogramming, resetting the BECM to ZERO is easy. After the correct mileage is programmed into the instrument cluster, the BECM will automatically update to the cluster figure as it will...

Too late me thinks, if you have fitted clocks with a higher mileage, the BECM will already have updated to the new higher mileage.

Blue print ref numbers. ADJ138048 are the bushes, ADJ138049 are the rear most bushes that fit to the chassis.

We replaced the hockey stick bushes and did the rear bushes as well. Solid mate💪 Just drop the anti roll bar and save yourself some grief 👍

Cheers. Just went to look at one on another 2000 car, seems to be plugged directly in with no cable on the RR. So the RL on mine had been changed. I am starting to think mine is bit a hacked up hybrid sensor cabling wise..... I have ordered a...

She's been drinking that super unleaded again 🤭

Approved! +2 🙌

Sounds like the system is airlocked. It looks like there is a mod to use the aircon fans or an additional electric fan for cooling. The first photo shows what looks like an adjustable thermostat.