What year the early ones were very specific about diag and somewhat limited on most systems 🤔

Yes. What's "aintgreen" ?? Do you mean not a green one.

Ha, Aintree Green*

Hi and welcome. I believe there is a link in the Technical Archive at top of page

A strange twist of events. Despite 2 modules missing, I reconnected 2 cables that were disconnected from the remaining units and now I have DAB, but no FM. I’m guessing it’s the FM units that have been removed. Either way that’ll do for the minute!

There you go

Very rare to need topping up. Follow the rear brake lines down, especially where they cross over the rear axle. Check for any dampness. If you have stainless steel braided flexis then check the ends for weeping.

Finally got round to changing FIP fuel pressure sensor and top gasket, how it managed to seal buy just tightening I'm not sure. It had gone hard and was quite compressed. Any way new one now fitted

Now then I forgot a Yorky. Could be onto something there

Our local Aldi has them in. Yummy

You can have my LHD one for 25000 centimes, mechanically good needs cosmetic work :rolleyes:

Humm iffy now if if we were talking a Yorky that would be different :vb-biggrin:

Not had a Double-decker in years. Or a Curly-wurly. You're definitely heading in the right direction.

Any advance on a Double Decker as well

And a bag of wine! blimey i would expect some midget gems and a curlywurly as well.

And a bag of wine gums:D

I'd have to look up the date, but my replacement O rings have lasted at least 12 years so far. That's jinxed it :rolleyes:

Unfortunately the autel 808 only sees it as an x5... I'm not sure if gap iid is the best for this year model. The later l322s are recognized by the mx808, 2006 onwards.

Damn, that's some mod work you got going on there. Very very few of of us on here do serious mods like your doing and this may be above some of us to answer dude. 🤔

They are the notches yes. I run the bead all the way along that top edge too so it joins up with the notch on the other side. And go around the coolant ports at the back and front. I've always has a weep of coolant from this area unless I seal...

Ex po po?

If it's the GM box, it barely copes with the standard M57.

The td6 is the m57? The early unit had a steel block and was a stronger engine. The later m57 was a weaker unit🤔

It's a p38 not a tratter!

Cant do that with the tools i got.. Luckily found a nice guy in finland with edc nanocom, willing to lend me his unit! I will get that later next week, hope i get the thing sorted and not end up with a yard decoration :D

The mileage will be in km won’t it? Japan use proper units don’t they?

I can't see their evaluations either or the other 27 vehicles/things they are selling🤷

I haven't got it yet but i can get one you can have for 10k!! Absolute bargain!! The pictures will be of how i think it should look but because it's a one off, some differences such as colour and condition cannot be guaranteed

let hope they do not pop off under pressure or strip the threads when tightening them ( it's not only birds that go cheap cheap)