If your EGR was anything like this one below, then your manifold and the MAP sensor attached to it will also be gunked up. 1 2 The seals gaskets are reusables' wipe then clean with a rag, 3 4 you want the manifold cleaned out as below. 5 6...

Boat anchor I recon.

Might as well. Think I’m done with this block. I discovered what cracked the block from the inside… part of the block (cylinder 1). Cylinder 1 piston was missing the lower ring as well.

Always worth checking any potential purchase previous mot history, tells you all sorts and depending on how long they have owned the car what they were like at repairs and generally spending money on it. https://www.carcheck.co.uk/

The problem is the front seal can be a right tawt as you can replace it and it can leak again and again and again, but you have to start somewhere! Not a massive job, your biggest issue will be finding any garage that is prepared to work on an...

When you fill a fliud (other than engine) in a land rover its called a fill/level plug and there is usually an oil stain around said plug, because you fill until it dribbles out. Post some more pics of it underneath. I dont know what you paid...

What code reader are they using?

Does it have a sunroof?

Spend 1/2 an hour on ebay and check what the parts alone are worth. S2 wiper motors good money 200 tdi decent money Galv chassis good money Then think of a number and see what they have to say, remember you can always go up.

As said rear x member looks to be on its last legs.

If they're in riv nuts, my money is on the riv nut spinning before the bolt remains come free. Before you spend a whole bunch of time on it, I would suggest making sure that your new fuel component mates up to the fuel lines perfectly still, as...

What happens is the oiltite bearings run dry and seizes ono the motor shaft, then the bush starts to spin in the motor housing dry and basically shags the whole thing. I tried to strip mine, gave up and bought a new one.

Final update: After replacing the temperature sensor and thermostat on my 300 TDI, I discovered the 3-way splitter on the overflow line was misrouted, sending the main coolant flow to the expansion tank instead of the radiator. Correcting the...

This is my build here: https://www.landyzone.co.uk/land-rover/200tdi-s3-88-pas-long-travel-suspension-rebuild.298104/ Having also got another 200Tdi powered Series, I'd also suggest moving the alternator to the other side of the engine. Gwyn...

Been jump started during the repair? Tried disconnecting the battery then joining the negative and positive battery leads together for a few seconds then reconnecting the battery?

Greetings. I thought I'd try and get a discussion going about problems - and the solutions to those problems - that your Landy might have in the cold. I have an '05 90 Td5 and I live in the Canadian arctic (but I'm a born and bred Brit so I feel...

Does d2 have fuel inertia cut off switch under bonnet?