That is terrible, looks like the vehicle has been used for launching boats into salt water.

If it isn't the rubbers and the shaft in the compressor itself is shaking about then it may have had it and will eventually seize.

Dont forget the dished washers on the pump mounts go a certain way they should dish )( that way not (). and whey only need to be nipped up not screwed down tight

@MrGorsky just took the LPG off his. Fit that, fill it and drive it in on gas. They'll have to test it on gas and it will almost certainly pass!

Normally I would say Lemforder although I had one of theirs and it failed within a year. On the plus side they replaced it under warranty.

Piccies?!

I got another toy!! I mean.. p38

have full set top and bottom ball joints (Delphi) available as Pay-it-Forward

That's not a pothole. That's a sink-hole.

In a bid to reduce my road tax and congestion charging bills, I've cleverly disguised the car as part of the Japanese Imperial Navy. Does anyone know how you get the diplomatic plates? eBay? Doesn't need to have the D dropped, I'm not that...

Hmm. A bit undecided on those light guards.

I find the older you get the longer it takes I did the rear bearing on my disco 3 and when i came to put it back togeather there was a return spring missing on the R /H side handbrake shoes i spent 3 days looking for it and then finally ordered...

Notice the P38s under cover - the kids sleep out in the rain 😂

Threw the tent on the roof and ventured out to the north of Dartmoor for the night.

I still have that. Took it oft before they collected the bus

Update. Well that was easy, just place a carpet over the modules under the seat (removing seat first) then lay on your back on the carpet, legs in the air, arms under the dash. Got it out and done what I wanted to. Now on to the next disaster.

Maybe they were an option. I thought all past '99 had them. Mind you, who knows what previous owners have done.

You'll loose some in the new filter. If your piston rings are all good then it might take a while to run down into the sump. Always fill, run for a few minutes and then top off.

Up to you but clear is right for your year.

Update I went to drop the tank but I decided to lift the back seat. I found a cut in the floor. Someone had went at it.. So I continued to remove sender.. The 2 nuts were a nitemare to remove, they were in bad shape.. I got them wit a lot of...

Check the leak off pipes, see if there is any diesel in the wells around the injectors, they are a regular failure item or is that what your have done when you say "changed fuel pipes"? Have you checked the voltage at the glow plugs? Another...

Misty tree.

Why does my auto carrot keep replacing right words with wrong ones?

Can you get a hose through an inspection plate or similar and give it a blast whilst very slowly easing the clutch in and out?

Don't think it was me.

😇 cheers Range Roller, it's very nice of all the lads to say hello and has made my day . Everybody seems to be still involved in helping each other out, which was the reason it was all set up originally and after all this time ids as strong as...

You sure that was an electric toothbrush?!

Was. @marjon was right. The mrs electric toothbrush cleaned the port up much better than mine 😊

My old head is in my scraps trailer. Given Mark is in France it'd probably be quicker and cheaper to just get the kit off eBay.

He's talking about the hole in the head it screws into. The bit you hope is flat.