I have this one ----

I have the X Eng big bulky thing. It does its job but is a pain to store when not fitted. I’d opt for the folding version.

Aye, that’s the sod :vb-hangin:

This is the one I have on mine. I know it is not strictly a Series 3 step but I think it looks ok and it acts as a useful rear bumper.

I’m leaning towards this as a solution. I have seen S3 with the right hand side cut off.

I can find the S3 steps however because of the tow plate I cannot anchor to the captive nuts. It’s a new crossmember I could fit new rivnuts I suppose.

I need to fit a rear step as I’m using the tow ball to get in and expect I’ll shin myself at some point. I thought I’d buy a S3 rear step but it won’t fit due to the towing plate. I could get the wide step that clamps to the tow hit, or I could...

ERR3652 https://parts.jaguarlandroverclassic.com/err3652-pipe-spill-return-fuel-injection.html https://www.lrdirect.com/err3652-spill-rail-200tdi

It’s a defender, it’ll be an earth at fault.

Nice forward control coming up for auction in Lincolnshire on 5 July if anyone knows someone looking for one.

It's a ground connection (to the seatbox through the handbrake mechanism itself). Is the bulb OK ?

Check the following Handbrake drum. Is this tight? When the prop goes on is it still tight? The UJs in the rear prop may have worn & need replacing. Is the big nut on the transfer box(behind the propshaft) tight?

The tractor runs I do tend to be about 10mph. Which on my super is low third so works ok. But is a little fast for the friends fordson standard. A B275 is acceptable because it is not grey!

Mate has a Super Major, it’s too fast for the tratter run.

International b275

I’ve got a matching numbers 110 CSW 200tdi sat in the garage where it’s been for 4 years. I’m wrestling with shifting it even though I love it and would love to put it back on the road. Been in my possession for 10 years. Then I have Brian’s...

Just ordered a noo tool. De Walt cordless angle grinder. Already got the batteries and charger, same as me cordless drill. Had to pay for it though, I said my name was Kev but they didn't believe me :confused: