TV module on mine did it.

If it was an L322 I would say try bypassing the Phone module or the sat nav with a fibre loop but it may not apply to a Disco 3 RRS

That might be my next problem but I'd like to have a radio to drown the noise as it dies.

At lest the crank hasn't snapped yet.

So a Disco 3 then :)

That's because they knew L322 owners would have a Recovery truck following them at all times :)

Air brake :)

This one worked for me

Well it drove straight out and back to almost the same spot :). After getting some supplies. J

Green P38 just passed MOT for another year with no advisories :):):)

Did you mean to post a pic of your lunch soup :oops:. J

Fixed my low screen wash warning. Fitted new sensor, ignition on, still there. Drained and cleaned out the washer bottle, refitted, igition on, still there. Found a broken wire, fixed it, ignition on, gone :) and only took 3 hours.

For me, the car is one of the few places that I can get away from the bloody TV.

The 4.4 westminster I had a go in last week had one. It's ace :)

To modern for me I'm afraid but I'm sure someone will know.

But you can still see it unless you drive with your eyes closed :) Or do you have the dual view screen?

No idea but It's illegal in the UK.

So I did desnow it today, but decided to take the defender to the shops. But now tomorrow ;). Gonna park the fender out somewhere safe and see if the L322 can do what the tin (never said) but hey if it gets beached the EAS will raise it and out...

There would be fuel pressure faults in the engines ecu to start with👍 Have your battery checked for capacity. It could be tired.

For me it started with taking longer to fire up. Usually it's on the button but it started taking longer and longer until the inevitable. If I used easystart it would start and run fine. I did end up fitting a new HP fuel pump as well but the...

Have you charged the battery? What does it read? What does the battery read while the engine cranks?

Or high pressure fuel regulator. Common fault.

Is it the same colour as yours? She wont notice ;). J

And changed the seats, headunit, gearstick, 🤔

Just tell her you removed the wrap ;). J

No it's silver but she still wouldn't notice :) I could get it wrapped in Black 🤔

I'm in love. Went for a spin in a 4.4 Westminster L322 while waiting for the wifes car to be mot'd 😍

I have tried nylon but it was very spongy and not sharp but now that I have sorted the parameters I think I know why. The PETG is fine and is used for automotive small parts so is ok for temps and weather

Thought you might be using one of those newfandagled resin jobbies. Not tried PETG but had real problems with nylon not sticking to the bed. Need to build an enclosure to keep the draught out.

What printer and material did you use please?