geoff1951

New Member
Hi all,

I have a 2005 Freelander XEI 1.8 K Series - Petrol. It has a misfire and I was wondering if there is anybody out there that has changed the fuel injectors on their Freelander.

I have already changed the plugs, coils and leads (twice), but now I think it might be the fuel injectors and/or the manifold gasket.

My question is: how easy is it to remove and replace the fuel injectors?

Thanks in advance for any help.

Regards
Geoff.
 
Do a compression test. Often the exhaust valves burn out on the K series engine. That was the reason I got mine as the previous owner didn't want to spend any money on it!
 
sorry : new to this : lit MIL???

Malfunction Indicator Lamp. Engine warning lamp.
If the light is lit of flashing, it indicates the engine ECU has logged the fault. Getting the codes read will give you an idea what is up.
 
Last edited:
Do a compression test as ZDomZ says they do burn the exhaust valves . If its present throughout the rev range and is a bad misfire this is probably what it is as you have just about changed everything else. If it is burnt valve then don't skimp and just change the burnt one change them all while the head is off.
 
as others have said do a compression test i had a valve go on a 1.8i in another car not sure if it was that that gave the main problem but i found this in the same cylinder worst case scenario

the valve in question
IM001884_zps6d411f8f.jpg


and what it may have done or vice-versa
good side
PICT0095_zpsc49c4422.jpg


bad side after i had cleaned it up
PICT0097_zpsa6865e8f.jpg

again it was dead easy to replace the liner and piston 2nd hand
car runs like a kitten now
Ron
 

Similar threads