1992 3.9 auto

My RR wasn't starting and I found the problem was the two pin to three pin adapter....it disintegrated and fell off due to its poor quality.

I've rigged up my own wires but I need to know which one goes where. Looking at the RR from the front, is the white wire to the back of the three pins and the black/white to the front, with the middle being null.

Secondly, I may have put the wires on back to front and start it, will this damage the module?

Thirdly, I'm making my own remote module mount and I have taken an old module apart to use as a dummy on the dizzy side. Can anyone tell me which input pins go to the ones that attach to the dizzy so I can solder some wires on the inside.

Thanks guys

Maybe fire an email to the manufacturer or distributor of the kit?

here you go

Thanks very much guys. With the new wiring she starts much better, right on the button! My home made remote position is nearly finished and the timing is also spot on. When I striped the wiring back the copper was all black and flaky.

Thanks again lads