J

jamesmartins

New Member

• Feb 8, 2015

• #1

HI, does any one know part number or this parts name its got a crack in it I need to replace it.

Many thanks.

its from the manifold to EGR TD6 3.0 bmw 2002 RR

 

Dippypud

Never Knowingly Understood

Full Member

• Feb 8, 2015

• #2

Throw it and fit an EGR by-pass :

AlliSport Range Rover 3 litre TD L322 EGR Removal Kit | eBay

 

J

jamesmartins

New Member

• Feb 8, 2015

• #3

Will that kit come with the part to blank off the Exhaust side or shall I just weld up the end bit and stick it back on.

The pipe seems to go via some sort of water cooling is this correct?


Could I just close the ERG manually and then just remove the vacuum line (put a screw in it)

 

Dippypud

Never Knowingly Understood

Full Member

• Feb 8, 2015

• #4

jamesmartins said:

Will that kit come with the part to blank off the Exhaust side or shall I just weld up the end bit and stick it back on.

The pipe seems to go via some sort of water cooling is this correct?


Could I just close the ERG manually and then just remove the vacuum line (put a screw in it)

Click to expand...

Some have done it with no issue ...

But it is your choice ...

On the td6 when the EGR activates the drop in flow is monitored by the ECU at the AFM, if it does not see that drop in air flow it defaults the ECU, puts the light on and goes into limp mode ...

You could simply pulled the vacuum hose off the EGR valve and plug it with a woodscrew.
Then take off the EGR valve, clean it out, check that the valve is closed to the exhaust inlet port and refit it leaving the vacuum pipe off...

Same effect as fitting a by-pass kit but at nil cost...and reversible ...

 

Dippypud

Never Knowingly Understood

Full Member

• Feb 8, 2015

• #5

Have a read here:

EGR blanking

 

J

jamesmartins

New Member

• Feb 8, 2015

• #6

many thanks
Dippypud

having a read now