MGRmanic · Jun 18, 2022

Please see the picture. Its a 2.5 DSE 1997, auto.
This was hanging off and I put it back in place. Quite oily so I'm guessing its some kind of breather at the top of the engine next to the oil filler cap.
Its not exactly secure so I'll keep an eye to see if it moves again.
I'm also guessing I will need to replace it.
Thanks.

Karlos the jackal · Jun 18, 2022

catches the oil from the engine stops it going in the inlet manifold should be a little gorse in there

MGRmanic · Jun 18, 2022

Thanks.
Looking again it appears there is a jubilee clip. Maybe it needs securing with a new one. A job for tomorrow.

Datatek · Jun 18, 2022

MGRmanic said:
Thanks.
Looking again it appears there is a jubilee clip. Maybe it needs securing with a new one. A job for tomorrow.

Normally there is no clip, both ends are a push fit on mine.

tomcat59alan · Jun 18, 2022

Datatek said:
Normally there is no clip, both ends are a push fit on mine.

+1^^,O ring on the stub that fits into the cam cover,the other pushes into a rubber grommet in the plastic intake.

tomcat59alan · Jun 18, 2022

tomcat59alan said:
+1^^,O ring on the stub that fits into the cam cover,the other pushes into a rubber grommet in the plastic intake.

That's the depression control valve.

MGRmanic · Jun 18, 2022

Are they available new or used only?
My instinct is to start to improve by renewing older bits. It is 25 years old after all. Summer project.

tomcat59alan · Jun 18, 2022

MGRmanic said:
Are they available new or used only?
My instinct is to start to improve by renewing older bits. It is 25 years old after all. Summer project.

They are available new but not cheap I believe.don't know if the discovery or Defender one will fit

MGRmanic · Jun 18, 2022

tomcat59alan said:
They are available new but not cheap I believe.don't know if the discovery or Defender one will fit

According to Ebay they don't so I've messaged the seller to check as they may well fit or supply the correct one.

tomcat59alan · Jun 18, 2022

MGRmanic said:
According to Ebay they don't so I've messaged the seller to check as they may well fit or supply the correct one.

There's a small pipe that fits to the bottom of the valve,held on by the jubilee clip that shows in your photo.

Datatek · Jun 19, 2022

MGRmanic said:
Are they available new or used only?
My instinct is to start to improve by renewing older bits. It is 25 years old after all. Summer project.

It really should not need to be replaced unless it's been butchered at some point. It's only a plastic container with some gauze inside to trap particles.

MGRmanic

Member

Karlos the jackal

Well-Known Member

MGRmanic

Member

Datatek

Well-Known Member

tomcat59alan

Well-Known Member

tomcat59alan

Well-Known Member

MGRmanic

Member

tomcat59alan

Well-Known Member

MGRmanic

Member

tomcat59alan

Well-Known Member

Datatek

Well-Known Member

Similar threads