Epicuser
Ex Freelander Owner
Kenwood BT73 DAB head unit. Clock/exterior temp (in place of clock). LED interior lighting. CG-Lock on seatbelt. HID headlights. CB mount on spare wheel. Tom Tom hard wired in. 12v auxiliary sockets fitted in the boot, Auxiliary socket fitted to centre armrest, Blackvue drive recorders fitted front and rear. scanguage 2.
where did you get the clock with outdoor temp on mate?
Epicuser
Ex Freelander Owner
I made it.....
edwardcraney2012
Active Member
Led light bar on roof, spot lights on lower half of the bumper (used an air con switch and swapped the cover from the blank switch above the rear fog switch to the air con switch that I etched a spot light symbol, makes the job look a bit more factory) , apline head unit installed with the hands free kit, steering controls for it retrofitted, led puddle lamps fitted, permanently live aux socket fitted in drivers cubby box, this means a power feed can go to the satnav on the windscreen with out the wires going across the dash, and a remote controlled relay and timer relay built in so I can press a blipper and my light come on for 30 seconds. Plans to add a switch so the reverse light can be turned on without being in reverse so they act as rear work lamps.
baptista
Active Member
Good idea!!! what about the wiring connections? got any pictures or diagrams of the process?
fitted front fogs over 1 year ago but I've had no luck finding a front fog switch at the breakers.
thequeenscheese
Well-Known Member
Can you do a how to for the steering wheel stereo controls?, got a switch from tannaton but haven't fitted it yet as it's a retro fit..
O e here but not much cheaper than the full kit on eBay..
Electrical | Freelander | British Parts UK
Altho looks like face-lift will fit..
Genuine Land Rover Freelander 1 Front Fog Light/Auxiliary Lamp Dashboard Switch YUG000320LNF 1996-2006
Could try these
Land Rover Addict Forums
thequeenscheese
Well-Known Member
Relays, Switches etc for Freelander One Page 2
Again expensive
But you could get a rear switch and use a rear wiper /wash wipe (or which ever the right lower one is) and swap the fronts I've but legally it's meant to be lit up when on . or also I think the blanket front clips on/off the same as switch fronts
Again expensive
But you could get a rear switch and use a rear wiper /wash wipe (or which ever the right lower one is) and swap the fronts I've but legally it's meant to be lit up when on . or also I think the blanket front clips on/off the same as switch fronts
Last edited:
thequeenscheese
Well-Known Member
edwardcraney2012
Active Member
Will get a couple pics when I get chance, you would need a spare air con connector for it too,
edwardcraney2012
Active Member
I changed the whole steering wheel so wouldn't know how to do just the switches,it looks like you would need to cut a bit out the side of the wheel.
And as for switches I originally had a rear wiper switch fitted but wanted the little light to tell me they were on so the ac switch works grand,
thequeenscheese
Well-Known Member
It was the wiring mainly as I don't think the harness exists in the commercial?
Dangermike
Active Member
Front spot lights on bumper, front fog lights,
LED rear work light,
LED interior lights,
Cathode tube boot lights,
RGB LED strip foot well lights, EL wire Cup holder light.....
LED rear work light,
LED interior lights,
Cathode tube boot lights,
RGB LED strip foot well lights, EL wire Cup holder light.....
