nathan5346
Well-Known Member
drain plugs btm of rad underneath 21mm socket
kernowdragon
Well-Known Member
Yup, that's the one. If you've got a plastic bung (which most are) be careful tightening it back up as the heads sheer off really easily. You can get brass ones to replace them with. If you want to drain all the water, there is also a drain plug on the drivers side of the engine block (about in the centre). I found a significant amount of water remained in the system unless you also do this one, and would distort the proportions of your anti-freeze mix.
kernowdragon
Well-Known Member
Depends.... Is it pre-mixed or concentrate? If it's pre-mixed you need to check the proportions are 50:50 (some may be less cause it's cheaper), or if concentrate it should be watered down to same. Not sure what effect of neat concentrate would be??
it wont matter - it will just get mixed in with the remaining coolant.
