TAKdriver
Active Member
Been replacing the washer pumps : Rave recommends removal of reservoir involving removal of wheel arch liner etc etc. Decided to do it in situ.
They just prise out with a screwdriver as somebody helpfully told me : pressing them back in is a real pain as it requires a hefty shove to click the body of the pump into the moulding in the reservoir and through the grommet/rubber washer.
Use a spreader clamp with one end out over the bottom of front bumper. It requires a bit of wiggling to get it in best position but did one in 2 mins this morning. Shoving on one last night took me over an hour and it wasn't in right.
They just prise out with a screwdriver as somebody helpfully told me : pressing them back in is a real pain as it requires a hefty shove to click the body of the pump into the moulding in the reservoir and through the grommet/rubber washer.
Use a spreader clamp with one end out over the bottom of front bumper. It requires a bit of wiggling to get it in best position but did one in 2 mins this morning. Shoving on one last night took me over an hour and it wasn't in right.
