Hi Guys,

With a shelf full of torque converters and various parts that go with and a long time since i have had time to work on this I can't remember how it all goes.

Do i have all the correct parts here in the correct order?


should it go like this?


it goes with this converter (hopfully)


It all seams to measure up good but was hoping someone knew the answer

thanks

looks about right ,once assembled you need to measure distance of rear most face of drive plate to block face ,then check t/c depth from bellhousing face t/c has to sit a mm or so deeper than drive plate protrudes, the shim for drive plate is selectable

Where does the shim fit? behind the smaller flex plate?

They are both approx 26/27mm but i couldn't find a good way to measure this, any tips?

thanks