hi hope the brains on here can help .
a freind of mine removed his xyz switch to replace it but the new one wont recognise the gears . i think he removed the old one in gear .
now my question is how can i manualy select park on the box so i can line it up with the switch ?
there has to be a god out there that can tell me this can be done ... i hope .

Rave says
Refit
1. Ensure 'P' is selected by rotating selector shaft
fully clockwise.
2. Engage 'N' by rotating selector shaft 2 detents
anti-clockwise.
3. Position inhibitor switch to selector shaft,
connect multiplug and secure multiplug to
gearbox bracket.
4. Engage switch to selector shaft, and fit but do
not tighten retaining bolts.
5. Fit tool LRT-44-011 to selector shaft.
6. Insert setting pin into tool. Rotate switch until
setting pin engages with hole in switch as
shown and tighten bolts to 10 Nm (7 lbf.ft).
7. Remove setting tool LRT-44-011.
8. Position selector lever to selector shaft and
tighten nut to 26 Nm (19 lbf.ft).
9. Diesel models: Fit exhaust front pipe.
+MANIFOLDS AND EXHAUST
SYSTEMS - Td5, REPAIRS, Pipe - front.

From this it looks like turning the selector shaft fully clockwise to get "P". Hope this helps.

ok thanks will give that a try at the weekend .