wickford90

wickford90

Well-Known Member
Couple of question, what is the best way to put in the top bolt as it seems to be really fiddly.Garage that put my last one on didn't bother, yee ha springs to mind.
and does anyone know where to buy a recon kit for the same, brush's etc.
Thanks.
 
Thanks for that, forgive me i'm not being picky but the nut in mine was 13mm. all i got to do now is get a bolt.
 
ive only ever seen the starters held on with 2 x 13mm headed bolts and one 15mm nut as 10mm thread ,nut been the one a back of starter
 
when i took the starter off i took out 2x13mm bolts, the third one was missing(assumed they were all the same) so that is a 15mm bolt and nut, does nut go to the rear or to the front.
 
Enjoyed throwing the top nut in the bin and leaving it there when I finally managed to get it off. No intention of putting anything back on the stud ! Some discussion on the forums suggesting this may not be wise but there are two bots holding the motor and one stud so I will take my chances.
 
chrimcne said:
Enjoyed throwing the top nut in the bin and leaving it there when I finally managed to get it off. No intention of putting anything back on the stud ! Some discussion on the forums suggesting this may not be wise but there are two bots holding the motor and one stud so I will take my chances.
Click to expand...

If you drive through deep water and mud you need it sealed best as poss. thats why mine has gone tits up.
 
You must log in or register to reply here.

Similar threads

S
starter motor questions
Replies
17
Views
1K
McBoon
McBoon
A
Disco 2 Starter Motor!!!!
2
Replies
26
Views
2K
Anaconda
A
SuperDaz
Wanted- Defender 90 300TDi or TD5 £15k budget
Replies
4
Views
1K
SuperDaz
SuperDaz
R
Top Nut missing on the starter, Disco2 TD5 Auto
Replies
5
Views
520
Anaconda
A
SuperDaz
Wanted- Defender 90 300TDi or TD5 £15k budget
Replies
4
Views
1K
SuperDaz
SuperDaz