I am trying to replace the master slave on SWMBOs FL1 TD4. It's all really simple except that I cannot separate the two pipes at that clip in joint.
It moves around a bit and will twist, but it just will not pull out.
I even thought of unscrewing the connector barrel from the slave cylinder pipe so that I can mess with it on the bench or buy a new one, but the nut seems screwed into that barrel mega hard.
I managed to extract the white plastic collar bit but after 90 mins trying the separate the rest :-(
Is there a special trick or is that it just needs a lot of force to pull it out?
It moves around a bit and will twist, but it just will not pull out.
I even thought of unscrewing the connector barrel from the slave cylinder pipe so that I can mess with it on the bench or buy a new one, but the nut seems screwed into that barrel mega hard.
I managed to extract the white plastic collar bit but after 90 mins trying the separate the rest :-(
Is there a special trick or is that it just needs a lot of force to pull it out?