8

88diesel new boy

New Member

• Jun 27, 2021

• #1

Hi all,
Getting ready to refit the cylinder head this weekend - I’ve noticed one of the tappet slides is missing a chunk…. It was running fine before hand - I’m keen to get it running again, is it worth the risk of leaving it? Is it straightforward to replace just the slide? I’ve attached a photo!

Cheers

 

Attachments

• 
  071D1C78-D377-4CF5-9039-C32FF8C8312A.jpeg

  378.8 KB · Views: 184

Europa486

Well-Known Member

• Jun 27, 2021

• #2

I wouldn’t take the risk, replace it, also where has that bit disappeared too would be my concern,

 

steve2286w

Well-Known Member

• Jun 28, 2021

• #3

Easy to replace , a bolt in top of block retains the outer slide which can be seen in the bore, pull it all out with a bent piece of wire, get a good one from Turner engineering dead cheap. The brass piece will be sitting in the sump

https://www.turnerengineering.co.uk/err-607-tappet-slide-c2x20634586

 

Last edited: Jun 28, 2021

L

lynall

Well-Known Member

Full Member

• Jun 28, 2021

• #4

No thats fooked good and proper.

 

steve2286w

Well-Known Member

• Jun 28, 2021

• #5

Succinctly said!

 

LordOWar

Well-Known Member

• Jun 28, 2021

• #6

lynall said:

No thats fooked good and proper.

Click to expand...

That pretty much sums it up.