Hi

I've done a search on here and found a few of the solutions to this problem, but so far none have worked for me.

I've got into the tailgate, pulled it apart, got the switch out, cleaned it up and refitted it.

That didn't work so I tried shorting the 2 connectors with some wire, again nothing.

I then read there could potentially be a loose wire in the drivers door, so I pulled that off and had a good look around, nothing untoward going on in there and I've had no problems with the doors at all.

Any idea what I should be looking at next as I'm now at a bit of a loss

Regards

Dave

Bump

Any ideas?

If the switch is good, have you tried to meter the wiring to check for continuity and power??

Also check the wiring diagrams and see if you can emulate the unlock signal to actuate the Latch motor....

It could be the latch motor is knackered....

Turned out it was the actuator that had popped its clogs, all fixed, £12 at the scrap yard well spent..