I

IREDefender110

New Member

• Apr 10, 2010

• #1

Hi,

Just got a standard land rover trailer harness and went to sawp it with the nato one that is connected up to it now.

Fitted everything and went to unplug the harness but no-matter what i do it wont come apart. There is a tap on one side that i have pushed, pulled etc. but noting.

What way is the tab suppose to work so it will release it.

Any help will be great.

John.

 

90truckcab

Well-Known Member

• Apr 10, 2010

• #2

if yer on bout the block connectors, use a small screwdriver in the tabs, they get a good grip

 

I

IREDefender110

New Member

• Apr 10, 2010

• #3

Ya its a block connector. I have used a flat head screw driver to push the tap in as far as it will go and pulled like mad but noting. I thought i was missing something.

 

90truckcab

Well-Known Member

• Apr 10, 2010

• #4

er, well if yer run out if ideas, cut the ****er off both bits and crimp yer new wires on

 

M

Mike_B

Active Member

• Apr 10, 2010

• #5

If its the same tab as on the normal civilain type towing plug, then push the tab (in the centre) in, and pull the plug downwards the raised bit in the middle, is part of the upper potion of the assembly, not the bottom. I tried to seperate the plug on my 110 and was pulling the wrong bit! the lower portion is the plug, the upper portion is the socket...