doobie
Active Member
i cant get mine to come back up!!
goes down and stays down!! i've not looked into it propperly yet but i've found all the linkages are pretty rusted up (this one's a series 2a) might be a starting point for you!
dr pepper
New Member
Tsv thats a bugger that, I has that on a tranny brake pipe, apllied brakes they worked but one side stuck on, same thing collapesed pipe, after a while it released took fecking ages to find that on.
You might want to try rocking the landy forwards and bacwards whilst putting a bit of pressure on the pedal to see if the clutch will let go, you'll get a good idea if the master cyl is ok but bleeding it first, if the master cylinder pumps brake fluid then its probably ok and a stuck clutch.
You might want to try rocking the landy forwards and bacwards whilst putting a bit of pressure on the pedal to see if the clutch will let go, you'll get a good idea if the master cyl is ok but bleeding it first, if the master cylinder pumps brake fluid then its probably ok and a stuck clutch.
Ayup,
Finally got round to looking at it, took the slave off and it was rusted solid. Guess that's the problem, trouble is i need to move the damn thing so am in the process of soaking it in oil. Don't really want to buy a new one just to move it two feet to the left on my drive. Got a new one on the diesel lump that just died, so i will swop it over once the two have swopped places on my drive.
Finally got round to looking at it, took the slave off and it was rusted solid. Guess that's the problem, trouble is i need to move the damn thing so am in the process of soaking it in oil. Don't really want to buy a new one just to move it two feet to the left on my drive. Got a new one on the diesel lump that just died, so i will swop it over once the two have swopped places on my drive.
