E

everreadyeddy

New Member

• Dec 11, 2008

• #1

batterys ok, seems like a connection or someone said an earth maybe?? turn the key and all the dash lights come on as usual then nothing at all when i give it the final turn. shoulfdnt be starter as new one was fitted a couple of months ago and i aint bin out in her much?? any ideas on what to check first??

thanks

 

L

landy 3.9v8

New Member

• Dec 11, 2008

• #2

try tapping the starter motor while somone holds it in the crank position see if you have nay luck?

 

motiztab

Member

• Dec 11, 2008

• #3

What engine? mate of mine said that TD5 burn out the starters, another mate of mine with a TD5 went through two in 6mths!
Check your earths, most faults are bad earths! not live.
You could check it by running a switch live down to the spade terminal after d.i
sconnecting the one already there.

 

vivnap

Banned

• Dec 11, 2008

• #4

it dont matter if the starter is new, they can still develop faults most usual is the solenoid after that it is the battery leads that bolt to it or the battery terminals that are dirty. dont laugh i have a JCB and had this problem, the dash lights came on but nothing when it came to starting it, after cleaning the battery terminals and connectors it started every time. also try the ignition relay and ignition. it could be an ignition fault ? youll need a tester to see if theres power to the solenoid wire (back of ignition lock) when you hold the key into the start position.

 

ratty

I'm not special I'm limited edition

• Dec 11, 2008

• #5

Take the ignition wire of the starter and then refit it again. See if it'll start then.

 

B

boydy1989

Well-Known Member

• Dec 12, 2008

• #6

check the switch on the end of the ignition barrel too. They can sometimes come loose and turn with the key for the final bit.

 

Big Vic

New Member

• Dec 12, 2008

• #7

Loose connection on starter motor