K

Ken9

New Member

• Dec 22, 2007

• #1

It is almost impossible to see the starter on my 1997 Disco 300 TDI let alone remove it without first removing other parts other parts.

What is the best way to get at it ?

If I remove the exhaust pipe can I remove it from below or do I also have to remove the manifold and turbo ?

Can I get at the starter solenoid connections without removing the starter ?

 

MattV8i

New Member

• Dec 12, 2008

• #2

I now have a 300TDI and my starter solenoid is sticking - can anyone answer Kens original message. Thanks.

 

I

iann41

New Member

• Dec 12, 2008

• #3

go here

300TDi Disco starter motor. - LR4x4 - The Land Rover Forum

Thx Ian

 

B

bordonladdie

Member

• Aug 20, 2009

• #4

I've just replaced a working Bosch Starter on my 1997 Disco 1 with a new Prestolite, which I had just in case. The Prestolite lasted just one week before the solenoid malfunction. Looks like I'll be refitting the Bosch tomorrow.

 

D

discomania

Well-Known Member

• Aug 20, 2009

• #5

Best bet is to get at it from the underside.

The turbo oil pipes get in the way a bit, but if you undo the 3 exhaust nuts from the manifold, you can get enough play in the exhaust (they have a flexi on them so no damage will be caused unless its shot) that you can then get the turbo out then once it clears the stud angle it down and withdraw it from the bottom.

Remember to disconnect your battery!

 

L

lagpunktortoni

New Member

• Oct 10, 2009

• #6

I removed mine from above - those instructions on the link sum it up pretty well. I have the Defender solid front pipe so not very accessible from below.

 

zan79

Well-Known Member

• Sep 3, 2012

• #7

iann41 said:

go here

300TDi Disco starter motor. - LR4x4 - The Land Rover Forum

Thx Ian

Click to expand...

I know I'm dragging up an old thread, But I would like to say 'thank you Ian' for putting up the link on here, was an absolute god send, Now if only the alternator didn't turn out to be a balls up it would have been a good day