T

Turnover

New Member

• Apr 24, 2010

• #1

Hi,

The problem is that the SRS light has come on. This is after the dash was taken out for the blend motors. I've tried to connect to the ECU with Faultmate with no luck. It times out. The supply is there and the coms wire is ok that goes from the SRS ECU to the diagnostic connector.

Any ideas?

Cheers

Chris

 

fanatic

RESPECT IS EARNED, BEATINGS ARE FREE ;-)

Forum Sponsor

• Apr 24, 2010

• #2

srs plug by dash clocks not plugged in?

 

T

Turnover

New Member

• Apr 24, 2010

• #3

Would that cause no coms?

 

Datatek

Well-Known Member

• Apr 24, 2010

• #4

the comms is irrelavant, according to RAVE, although up to 5 faults are stored in the SRS ECU, the SRS lights should go out on the next ignition cycle after the fault has been corrected. In my case the fault is due to the drivers side airbag. I am about to sort it after reading RAVE, I will let you know if the SRS light does in fact go out when I fix the fault.

 

the hooded claw

Well-Known Member

• Apr 24, 2010

• #5

Datatek said:

the comms is irrelavant, according to RAVE, although up to 5 faults are stored in the SRS ECU, the SRS lights should go out on the next ignition cycle after the fault has been corrected. In my case the fault is due to the drivers side airbag. I am about to sort it after reading RAVE, I will let you know if the SRS light does in fact go out when I fix the fault.

Click to expand...

It Won't Data, ........... SRS is a HARD FAULT it'll need to be "Testbooked" to remove

 

Datatek

Well-Known Member

• Apr 24, 2010

• #6

You might be right but that ain't what it says in RAVE.