BuzzLand

Active Member
Well I got three of the four bolts out for removing my bumper and spotlight mount steelwork.

On the forth one though I unfortunately snapped the bloody bolt off. :(

It seems to penetrate a threaded retaining plate so can't be yanked out. I've tried to remove the bumper but, predicatably the snapped-off stud is preventing it.

Is there any way to remove it without resorting to a bolt extractor?

Any hints and tips appreciated.

lbe1Yei.jpg


KLSrTfj.jpg
 
Was here once many years ago.
Fairly certain you can cut through the bottom of the bolt using a hacksaw blade, remove the bumper and then get access to the captive-nut.
 
All four of mine sheared off last week! I found that I could tap the bit of stud down and lever the bumper off.
New bolts and captive nuts from Paddocks or another on line supplier and back in business :)
 
All four of mine sheared off last week! I found that I could tap the bit of stud down and lever the bumper off.
New bolts and captive nuts from Paddocks or another on line supplier and back in business :)
Were you able to tap the bolt down and clear despite it being in the threaded plate section / captive bolt section? Which is where mine is at right now...
I have the tools for punching steelwork down, never tried it for a threaded bolt though, I figure I'd need an engineers hammer for that?
 
Were you able to tap the bolt down and clear despite it being in the threaded plate section? Which is where mine is at right now...
Yes indeed. I was in the same predicament, I used a 10mm diameter rod and a lump hammer. A couple of good hits and the bracket will move.
Cheers
 
Alright folks, I got it off in the end. I couldn't tap the bolt out as such as it was rocking about too much, but instead I wiggled the bumper off after jiggery-pokery and then grinded the stub off.
 
Alright folks, I got it off in the end. I couldn't tap the bolt out as such as it was rocking about too much, but instead I wiggled the bumper off after jiggery-pokery and then grinded the stub off.
Glad you got it sorted :)
 
Another fabulous piece of design! It's all part of the Land Rover engineering apprenticeship "get the big hammer"!
 

Similar threads